cpfrMapUnreachableType
CISCO-PFR-MIB ·
.1.3.6.1.4.1.9.9.772.1.2.1.34
Object
column
r/w
PfrMetricPolicyType
This object specifies the unreachable type configuration used by PfR. It is used to set the relative percentage or the absolute maximum number of unreachable hosts, based on flows per million (fpm), that PfR will permit from a PfR-managed exit link.
Context
- MIB
- CISCO-PFR-MIB
- OID
.1.3.6.1.4.1.9.9.772.1.2.1.34- Type
- column
- Access
- readwrite
- Status
- current
- Parent
- cpfrMapEntry
- Table
- cpfrMapTable
- Siblings
- 39
Syntax
PfrMetricPolicyType
- Source
- PfrMetricPolicyType
- Base type
Enumeration
Values & Constraints
Type Values
1 | relative |
2 | threshold |
Related Objects
Sibling Objects
| Object | Type | Syntax | OID |
|---|---|---|---|
| cpfrMapIndex This object indicates an arbitrary integer-value that uniquely
identifies a set of PfR policy maps. | column | PfrMapIndex | .1.3.6.1.4.1.9.9.772.1.2.1.1 |
| cpfrMapDelayRelativePercent This object specifies a relative delay threshold based on a
comparison of short-term and long-term delay percentages. The
value of this object is valid if the corresponding value… | column | tenths of percent Unsigned32 | .1.3.6.1.4.1.9.9.772.1.2.1.10 |
| cpfrMapDelayThresholdMax This object specifies the absolute maximum delay time. The
value of this object is valid if the corresponding value of
cpfrMapDelayType is set to 'threshold'. | column | milliseconds Unsigned32 | .1.3.6.1.4.1.9.9.772.1.2.1.11 |
| cpfrMapHolddownTimer This object specifies the route dampening time period.
It is used to configure the prefix route dampening timer for
the minimum period of time in which a new exit must be used
bef… | column | seconds Unsigned32 | .1.3.6.1.4.1.9.9.772.1.2.1.12 |
| cpfrMapPrefixForwardInterface This object specifies whether or not a null forwarding
interface has been configured. This interface is always
up and can never forward or receive traffic; encapsulation
always… | column | CISCO-TCInterfaceIndexOrZero | .1.3.6.1.4.1.9.9.772.1.2.1.13 |
| cpfrMapJitterThresholdMax This object specifies the maximum tolerable jitter value
permitted on an exit link. | column | milliseconds Unsigned32 | .1.3.6.1.4.1.9.9.772.1.2.1.14 |
| cpfrMapLinkGroupName This object specifies the primary link group to be used by PfR
to select an exit. It allows a group of exit links to be
defined as a preferred set of links for PfR to use when
… | column | SNMP-FRAMEWORK-MIBSnmpAdminString | .1.3.6.1.4.1.9.9.772.1.2.1.15 |
| cpfrMapFallbackLinkGroupName This object specifies a fallback link group to be used if all
the exits in the primary link group are out-of-policy (OOP). | column | SNMP-FRAMEWORK-MIBSnmpAdminString | .1.3.6.1.4.1.9.9.772.1.2.1.16 |
| cpfrMapLossType This object specifies the loss type configuration used by PfR.
It specifies the relative percentage or maximum number of
packets that PfR will permit to be lost during transmissi… | column | PfrMetricPolicyType | .1.3.6.1.4.1.9.9.772.1.2.1.17 |
| cpfrMapLossRelativeAvg This object specifies a relative percentage of packet loss
based on a comparison of short-term and long-term packet loss
percentages. The value of this object is valid if the
cor… | column | tenths of percent Unsigned32 | .1.3.6.1.4.1.9.9.772.1.2.1.18 |
| cpfrMapLossThresholdMax This object specifies absolute packet loss based on packets per
million (PPM). The value of this object is valid if the
corresponding value of cpfrMapLossType is set to 'threshol… | column | packets-per-million Unsigned32 | .1.3.6.1.4.1.9.9.772.1.2.1.19 |
| cpfrMapPolicyIndex This object indicates an arbitrary integer-value that, in
combination with cpfrMapIndex, uniquely identifies a PfR policy
map. | column | PfrMapPolicyIndex | .1.3.6.1.4.1.9.9.772.1.2.1.2 |
| cpfrMapModeMonitor This object specifies how a PfR MC using this PfR map should
monitor the TCs.
'active'
Enable active monitoring.
'activethrougput'
Enable acti… | column | Enumeration | .1.3.6.1.4.1.9.9.772.1.2.1.20 |
| cpfrMapModeRouteOpts This object specifies how a PfR MC using this PfR map should
control the TCs.
'control'
Monitor and report performance data and use the data to
make route cha… | column | Enumeration | .1.3.6.1.4.1.9.9.772.1.2.1.21 |
| cpfrMapRouteMetricBgpLocalPref This object specifies the BGP local preference for PfR
controlled routes. The value of this object is valid if the
corresponding value of cpfrMapModeRouteOpts is set to 'metric'.… | column | Unsigned32 | .1.3.6.1.4.1.9.9.772.1.2.1.22 |
| cpfrMapRouteMetricEigrpTagCommunity This object specifies the community value to an EIGRP route
under PfR control. The value of this object is valid if the
corresponding value of cpfrMapModeRouteOpts is set to 'met… | column | Unsigned32 | .1.3.6.1.4.1.9.9.772.1.2.1.23 |
| cpfrMapRouteMetricStaticTag This object specifies the tag to a static route under PfR
control. The value of this object is valid if the
corresponding value of cpfrMapModeRouteOpts is set to 'metric'.
The v… | column | Unsigned32 | .1.3.6.1.4.1.9.9.772.1.2.1.24 |
| cpfrMapModeSelectExitType This object specifies how a PfR MC using this PfR map should
select an exit based on performance or policy.
'best'
Select the best exit based on performance or p… | column | Enumeration | .1.3.6.1.4.1.9.9.772.1.2.1.25 |
| cpfrMapMOSThresholdMin This object specifies a threshold MOS value that represents a
minimum voice quality for exit link utilization. | column | Unsigned32 | .1.3.6.1.4.1.9.9.772.1.2.1.26 |
| cpfrMapMOSPercentage This object specifies a percentage value that is compared
with the percentage of MOS samples that are below the MOS
threshold. The number of MOS samples over a period of time th… | column | percent Unsigned32 | .1.3.6.1.4.1.9.9.772.1.2.1.27 |
| cpfrMapNextHopAddressType This object specifies the address type of the address specified
as the next hop when PfR is used for sinkhole filtering. | column | INET-ADDRESS-MIBInetAddressType | .1.3.6.1.4.1.9.9.772.1.2.1.28 |
| cpfrMapNextHopAddress This object specifies the next hop address to which PfR
forwards packets for matching prefixes. The prefixes that are
forwarded to the next hop address are specified by an access… | column | INET-ADDRESS-MIBInetAddress | .1.3.6.1.4.1.9.9.772.1.2.1.29 |
| cpfrMapStorageType This object specifies the memory realization of the row. The
following columnar objects are allowed to be writable when the
storageType of this entry is permanent(4):
cpfrMapInde… | column | SNMPv2-TCStorageType | .1.3.6.1.4.1.9.9.772.1.2.1.3 |
| cpfrMapPeriodicTimer This object specifies the periodic timer that PfR uses to
select the best exit for the matched TCs. When this timer
expires, PfR automatically selects the best exit,
irrespective… | column | seconds Unsigned32 | .1.3.6.1.4.1.9.9.772.1.2.1.30 |
| cpfrMapActiveProbeFrequency This object specifies the frequency of active probes configured
under a PfR map. | column | seconds Unsigned32 | .1.3.6.1.4.1.9.9.772.1.2.1.31 |
| cpfrMapActiveProbePackets This object specifies the number of probe packets generated
for each active probe cycle. | column | packets Unsigned32 | .1.3.6.1.4.1.9.9.772.1.2.1.32 |
| cpfrMapTracerouteReporting This object enables continuous and policy-based traceroute
probing. Traceroute probing allows prefix performance to be
measured on a hop-by-hop basis. Delay, loss, and
reachabil… | column | Bits | .1.3.6.1.4.1.9.9.772.1.2.1.33 |
| cpfrMapUnreachableRelativeAvg This object specifies a relative percentage of unreachable
hosts. The relative unreachable host percentage is based on a
comparison of short-term and long-term measurements. The… | column | tenths of percent SNMPv2-SMIUnsigned32 | .1.3.6.1.4.1.9.9.772.1.2.1.35 |
| cpfrMapUnreachableThresholdMax This object specifies the absolute maximum number of
unreachable hosts based on flows per million.
The value of this object is valid if the corresponding
value of cpfrMapUnreac… | column | flows per million Unsigned32 | .1.3.6.1.4.1.9.9.772.1.2.1.36 |
| cpfrMapRoundRobinResolver This object specifies whether the round robin resolver is
enabled or disabled.
'enable'
Round robin resolver is enabled.
'disable'
Round robin … | column | Enumeration | .1.3.6.1.4.1.9.9.772.1.2.1.37 |
| cpfrMapEventNotifCtrlType This object specifies the event notification control type
configuration used by PfR. It is used to set the relative
percentage or the absolute threshold value for
cpfrMapEventNot… | column | PfrMetricPolicyType | .1.3.6.1.4.1.9.9.772.1.2.1.38 |
| cpfrMapEventNotifCtrlThreshold This object specifies the absolute event counter threshold or
relative percentage threshold used by PfR to throttle the
generation of cpfrTCInpolicyThresholdBelowNotify and
cpfrTC… | column | SNMPv2-SMIUnsigned32 | .1.3.6.1.4.1.9.9.772.1.2.1.39 |
| cpfrMapRowStatus This object specifies the status of a row in the PfR map table.
The following columnar objects must be valid in order to
transition the row to the active state:
cpfrMapName.
… | column | SNMPv2-TCRowStatus | .1.3.6.1.4.1.9.9.772.1.2.1.4 |
| cpfrMapEventTCCount This object specifies the current absolute number of traffic
classes, whose state are 'default' or 'oopolicy' specified by
cpfrTCStatus. | column | SNMPv2-SMIUnsigned32 | .1.3.6.1.4.1.9.9.772.1.2.1.40 |
| cpfrMapName This object specifies the name of a PfR map. | column | SNMP-FRAMEWORK-MIBSnmpAdminString | .1.3.6.1.4.1.9.9.772.1.2.1.5 |
| cpfrMapBackoffMinTimer This object specifies the minimum value for the backoff timer.
The backoff timer is used to configure a PfR map to set the
transition period for which the MC holds an out-of-polic… | column | seconds Unsigned32 | .1.3.6.1.4.1.9.9.772.1.2.1.6 |
| cpfrMapBackoffMaxTimer This object specifies the maximum value for the backoff timer.
If the maximum timer expires and all PfR-managed exits are
out-of-policy, PfR will install the best available exit a… | column | seconds Unsigned32 | .1.3.6.1.4.1.9.9.772.1.2.1.7 |
| cpfrMapBackoffStepTimer This object specifies the time period value for the step timer.
PfR users the step timer to add time to the out-of-policy
waiting period each time the backoff timer expires and Pf… | column | seconds Unsigned32 | .1.3.6.1.4.1.9.9.772.1.2.1.8 |
| cpfrMapDelayType This object specifies the delay type of a PfR map. It is used
to set the delay threshold as a relative percentage or as an
absolute value for match criteria. | column | PfrMetricPolicyType | .1.3.6.1.4.1.9.9.772.1.2.1.9 |