coiOpticalControllerStatus

This object indicates the current defect status of the Optics
layer.
noDefect(0):       No Defect. This bit is set high when no
                   defect is detected on the optics.
improprmvl(1):     Improper Removal. This will be set when
                   a physical pluggable is absent on a service
                   (hw-module) provisioned port.
mea(2):            This bit will be set when Port Pluggable
                   Module Mismatches With Pre-Provisoned PPM.
provMismatch(3):   Provision Mismatch. This bit is set when
                   Provisioned wavelength is Not supported By
                   Pluggable.
highRXPwr(4):      High Receive Power. This bit is set when the
                   measured optical power of the received
                   signal exceeds the threshold high value,
                   which is user-provisionable.
highTXPwr(5):      High Transmit Power. This bit is set when
                   Pluggable measured optical power of the
                   transmitted signal falls over the threshold.
lowRXPwr(6):       Low Receive Power. This bit is set when the
                   measured optical power of the received
                   signal falls below the low threshold value,
                   which is user-provisionable.
lowTXPwr(7):       Low Transmit Power. This bit is set when
                   Pluggable measured optical power of the
                   transmitted signal falls below the low
                   threshold.
highLBC(8):        High Laser Bias. This bit is set when the
                   Physical Pluggable Port laser reads laser
                   bias value beyond configured high threshold.
highDGD(9):        High DGD. This bit is set when the pluggable
                   port Module reads the Differential Group
                   delay value that exceeds the configured high
                   threshold.
outOfRangeCD(10):  Out of Range Chromatic Dispersion. This bit
                   is set when the Chromatic dispersion value
                   read by the associated HW is out of range
                   with the configured threshold.
lowOSNR(11):       Low Optical Signal to Noise Ratio. This bit
                   is set when the HW read Optical Signal to
                   Noise ratio falls below the configured low
                   threshold.
wvlOutOfLock(12):  Wavelength Out of Lock. This bit is set when
                   Trunk Port optics detects that optical input
                   frequency is out of range.
highLaserTemp(13): High LaserTemp.This bit is set when the
                   internally measured transceiver temperature
                   exceeds the card setting by 35.6 degrees F
                   or 2 degrees C. A laser temperature change
                   affects the transmitted wavelength.
lowLaserTemp(14):  Low LaserTemp. This bit is set when the
                   internally measured transceiver temperature
                   falls below the card setting by 35.6 degrees
                   F or 2 degrees C. A laser temperature change
                   affects the transmitted wavelength. (This
                   temperature is equivalent to about 200
                   picometers of wavelength.
ppmFail(15):       Pluggable Equipment Fail. This bit is set
                   when Pluggable Equipment is not operational
                   or manageable.
This object is sent out as a notification to the agent.

MIB

CISCO-OPTICAL-MIB

OID

.1.3.6.1.4.1.9.9.828.1.1.2.1.12

Type

column

Access

readonly

Status

current

Parent

coiOpticalControllerEntry