cdtIfIpv6NdOpts
CISCO-DYNAMIC-TEMPLATE-MIB ·
.1.3.6.1.4.1.9.9.784.1.2.1.1.22
Object
column
r/w
Bits
This object specifies options that affect advertisements sent
on the target interface:
'advertise'
This option specifies that the system should advertise
the IPv6 prefix (i.e., the corresponding instance of
cdtIfIpv6NdPrefix).
'onlink'
This option specifies that the IPv6 prefix has been
assigned to a link. If set to '0', the system
advertises the IPv6 prefix as 'offlink'.
'router'
This option indicates that the router will send the full
router address and not set the 'R' bit in prefix
advertisements.
'autoConfig'
This option indicates to hosts on the local link that
the specified prefix supports IPv6 auto-configuration.
'advertisementInterval'
This option specifies the advertisement interval option
in router advertisements sent on the target interface.
'managedConfigFlag'
This option causes the system to set the 'managed
address configuration flag' in router advertisements
sent on the target interface.
'otherConfigFlag'
This option causes the system to set the 'other stateful
configuration' flag in router advertisements sent on the
target interface.
'frameIpv6Prefix'
This option causes the system to add the prefix in a
received RADIUS framed IPv6 prefix attribute to the
target interface's neighbor discovery prefix queue and
includes it in router advertisements sent on the target
interface.
'raSupress'
This option suppresses the transmission of router
advertisements on the target interface.
This column is valid only if the 'ipv6NdOpts' bit of the
corresponding instance of cdtIfValid is '1'.
Context
- MIB
- CISCO-DYNAMIC-TEMPLATE-MIB
- OID
.1.3.6.1.4.1.9.9.784.1.2.1.1.22- Type
- column
- Access
- readwrite
- Status
- current
- Parent
- cdtIfTemplateEntry
- Table
- cdtIfTemplateTable
- Siblings
- 29
Syntax
Bits
Values & Constraints
Enumerated Values
0 | advertise |
1 | onlink |
2 | router |
3 | autoConfig |
4 | advertisementInterval |
5 | managedConfigFlag |
6 | otherConfigFlag |
7 | framedIpv6Prefix |
8 | raSuppress |
Related Objects
Sibling Objects
| Object | Type | Syntax | OID |
|---|---|---|---|
| cdtIfValid This object specifies which attributes in the dynamic template
have been configured to valid values.
Each bit in this bit string corresponds to a column in this
tab… | column | Bits | .1.3.6.1.4.1.9.9.784.1.2.1.1.1 |
| cdtIfIpv4VerifyUniRpfAcl This object specifies the name (or number) of the IPv4 ACL
used to determine whether the system should permit/deny packets
received by the target interface that fail unicast RPF
v… | column | OctetString | .1.3.6.1.4.1.9.9.784.1.2.1.1.10 |
| cdtIfIpv4VerifyUniRpfOpts This object specifies the options that affect how the system
performs unicast RPF on IPv4 packets received by the target
interface.
This column is valid only if the… | column | CISCO-IP-URPF-MIBUnicastRpfOptions | .1.3.6.1.4.1.9.9.784.1.2.1.1.11 |
| cdtIfIpv6Enable This object specifies whether the system processes IPv6
packets received by the target interface.
This column is valid only if the 'ipv6Enable' bit of the
correspon… | column | SNMPv2-TCTruthValue | .1.3.6.1.4.1.9.9.784.1.2.1.1.12 |
| cdtIfIpv6SubEnable This object specifies whether the target interface allows IPv6
subscriber sessions.
This column is valid only if the 'ipv6SubEnable' bit of the
corresponding instan… | column | SNMPv2-TCTruthValue | .1.3.6.1.4.1.9.9.784.1.2.1.1.13 |
| cdtIfIpv6TcpMssAdjust This object specifies the adjustment to the Maximum Segment
Size (MSS) of TCP SYN packets received by the target interface
contained in IPv6 datagrams.
The value '0… | column | octets Unsigned32 | .1.3.6.1.4.1.9.9.784.1.2.1.1.14 |
| cdtIfIpv6VerifyUniRpf This object specifies whether the type of unicast RPF the
system performs on IPv6 packets received by the target
interface.
This column is valid only if the 'ipv6Ve… | column | CISCO-IP-URPF-MIBUnicastRpfType | .1.3.6.1.4.1.9.9.784.1.2.1.1.15 |
| cdtIfIpv6VerifyUniRpfAcl This object specifies the name (or number) of the IPv6 ACL
used to determine whether the system should permit/deny packets
received by the target interface that fail unicast RPF
v… | column | OctetString | .1.3.6.1.4.1.9.9.784.1.2.1.1.16 |
| cdtIfIpv6VerifyUniRpfOpts This object specifies the options that affect how the system
performs unicast RPF on IPv6 packets received by the target
interface.
This column is valid only if the… | column | CISCO-IP-URPF-MIBUnicastRpfOptions | .1.3.6.1.4.1.9.9.784.1.2.1.1.17 |
| cdtIfIpv6NdPrefix This object specifies the IPv6 network number included in
IPv6 router advertisements sent on the target interface.
This column is valid only if the 'ipv6NdPrefix' b… | column | INET-ADDRESS-MIBInetAddressIPv6 | .1.3.6.1.4.1.9.9.784.1.2.1.1.18 |
| cdtIfIpv6NdPrefixLength This object specifies the length of the IPv6 prefix specified
by the corresponding instance of cdtIpv6NdPrefix.
This column is valid only if the 'ipv6NdPrefix' bit … | column | INET-ADDRESS-MIBInetAddressPrefixLength | .1.3.6.1.4.1.9.9.784.1.2.1.1.19 |
| cdtIfMtu This object specifies the Maximum Transfer Unit (MTU) size for
all packets sent on the target interface.
The value '0' cannot be written to an instance of this obje… | column | octets Unsigned32 | .1.3.6.1.4.1.9.9.784.1.2.1.1.2 |
| cdtIfIpv6NdValidLife This object specifies the interval that the system advertises
the IPv6 prefix (i.e., the corresponding instance of
cdtIfIpv6NdPrefix) as 'valid' for IPv6 router advertisements
sen… | column | seconds Unsigned32 | .1.3.6.1.4.1.9.9.784.1.2.1.1.20 |
| cdtIfIpv6NdPreferredLife This object specifies the interval that the system advertises
the IPv6 prefix (i.e., the corresponding instance of
cdtIfIpv6NdPrefix) as 'preferred' for IPv6 router advertisements… | column | seconds Unsigned32 | .1.3.6.1.4.1.9.9.784.1.2.1.1.21 |
| cdtIfIpv6NdDadAttempts This object specifies the number of consecutive neighbor
solitication messages the system sends on the target interface
while performing duplicate address detection on unicast IPv… | column | Unsigned32 | .1.3.6.1.4.1.9.9.784.1.2.1.1.23 |
| cdtIfIpv6NdNsInterval This object specifies the interval between neighbor
solicitation retransmissions on the target interface.
This column is valid only if the 'ipv6NdNsIntervals' bit o… | column | milliseconds Unsigned32 | .1.3.6.1.4.1.9.9.784.1.2.1.1.24 |
| cdtIfIpv6NdReachableTime This object specifies the amount of time the system considers
a neighbor of the target interface reachable after a
reachability confirmation event has occurred. The value '0'
dis… | column | milliseconds Unsigned32 | .1.3.6.1.4.1.9.9.784.1.2.1.1.25 |
| cdtIfIpv6NdRaIntervalUnits This object specifies the units of time for the corresponding
instances of cdtIfIpv6NdRaIntervalMin and
cdtIfIpv6NdRaIntervalMax.
This column is valid only if the '… | column | Enumeration | .1.3.6.1.4.1.9.9.784.1.2.1.1.26 |
| cdtIfIpv6NdRaIntervalMax This object specifies the maximum interval between IPv6 router
advertisements sent on the target interface.
The value '0' cannot be written to an instance of this o… | column | Unsigned32 | .1.3.6.1.4.1.9.9.784.1.2.1.1.27 |
| cdtIfIpv6NdRaIntervalMin This object specifies the minimum interval between IPv6 router
advertisements sent on the target interface. The value of this
column has the following restrictions:
… | column | Unsigned32 | .1.3.6.1.4.1.9.9.784.1.2.1.1.28 |
| cdtIfIpv6NdRaLife This object specifies the router lifetime value in IPv6 router
advertisements sent on the target interface. The value '0'
specifies that neighbors should not consider the router … | column | seconds Unsigned32 | .1.3.6.1.4.1.9.9.784.1.2.1.1.29 |
| cdtIfCdpEnable This object specifies whether the target interface participates
in the Cisco Discovery Protocol (CDP).
This column is valid only if the 'cdpEnable' bit of the
corre… | column | SNMPv2-TCTruthValue | .1.3.6.1.4.1.9.9.784.1.2.1.1.3 |
| cdtIfIpv6NdRouterPreference This object specifies the Default Router Preference (DRP) for
the router on the target interface.
This column is valid only if the 'ipv6NdRouterPreference' bit of
t… | column | Enumeration | .1.3.6.1.4.1.9.9.784.1.2.1.1.30 |
| cdtIfFlowMonitor This object specifies the name of the flow monitor associated
with the target interface.
This column is valid only if the 'flowMonitor' bit of the
corresponding ins… | column | OctetString | .1.3.6.1.4.1.9.9.784.1.2.1.1.4 |
| cdtIfIpv4Unnumbered This object specifies the interface of the source address that
the target interface uses when originating IPv4 packets.
The value '0' cannot be written to an instan… | column | IF-MIBInterfaceIndexOrZero | .1.3.6.1.4.1.9.9.784.1.2.1.1.5 |
| cdtIfIpv4SubEnable This object specifies whether the target interface allows IPv4
subscriber sessions.
This column is valid only if the 'ipv4SubEnable' bit of the
corresponding instan… | column | SNMPv2-TCTruthValue | .1.3.6.1.4.1.9.9.784.1.2.1.1.6 |
| cdtIfIpv4Mtu This object specifies the Maximum Transfer Unit (MTU) size for
IPv4 packets sent on the target interface.
The value '0' cannot be written to an instance of this obj… | column | octets Unsigned32 | .1.3.6.1.4.1.9.9.784.1.2.1.1.7 |
| cdtIfIpv4TcpMssAdjust This object specifies the adjustment to the Maximum Segment
Size (MSS) of TCP SYN packets received by the target interface
contained in IPv4 datagrams.
The value '0… | column | octets Unsigned32 | .1.3.6.1.4.1.9.9.784.1.2.1.1.8 |
| cdtIfIpv4VerifyUniRpf This object specifies whether the type of unicast RPF the
system performs on IPv4 packets received by the target
interface.
This column is valid only if the 'ipv4Ve… | column | CISCO-IP-URPF-MIBUnicastRpfType | .1.3.6.1.4.1.9.9.784.1.2.1.1.9 |