ccasLSTCASDebounceTimer

CISCO-CAS-IF-EXT-MIB · .1.3.6.1.4.1.9.9.314.1.3.3.1.8

MIB view Table view

Object

column r/w milliseconds Unsigned32

This object specifies the amount of time for which the line 
signal should persist to be valid. 
The value of ccasLSTCASDebounceTimer must be less than or 
equal the value of following objects:
ccasILSMinMakeTime,              
ccasILSMaxMakeTime,             
ccasILSMinBreakTime,             
ccasILSMaxBreakTime in ccasIfExtIncomingLineSignalTable.

Context

MIB: CISCO-CAS-IF-EXT-MIB
OID: .1.3.6.1.4.1.9.9.314.1.3.3.1.8
Type: column
Access: readwrite
Status: current
Units: milliseconds
Parent: ccasIfExtLineSignalTimerEntry
Table: ccasIfExtLineSignalTimerTable
Siblings: 11

Syntax

milliseconds Unsigned32

Values & Constraints

Object Constraints

range: 1-4294967295

Related Objects

Sibling Objects

Object	Type	Syntax	OID
ccasLSTIndex An arbitrary index that uniquely identifies a entry in the ccasIfExtLineSignalTimerTable. The index 1 is reserved for the default entry.	column	Unsigned32	`.1.3.6.1.4.1.9.9.314.1.3.3.1.1`
ccasLSTDelayBetRegAnsAndLineAns This object specifies the timer that will be started after register signaling completes successfully, within which the answer line signal should be received. This applies to o…	column	seconds Unsigned32	`.1.3.6.1.4.1.9.9.314.1.3.3.1.10`
ccasLSTSeizeAckToDigitTimer This object specifies the amount of time that the GW should wait for the reception address digits after sending seize ack signal. The value of 0 indicates the timer will not be…	column	seconds Unsigned32	`.1.3.6.1.4.1.9.9.314.1.3.3.1.11`
ccasLSTRowStatus This object is used for adding, deleting, and modifying the entries from the ccasIfExtLineSignalTimerTable. A default entry with index value 1 is created at initialization, and…	column	SNMPv2-TCRowStatus	`.1.3.6.1.4.1.9.9.314.1.3.3.1.12`
ccasLSTIdleGuardTimer This object specifies the maximum amount of time MG will wait for receipt of the idle signal on the line. For T1 interfaces idle signal corresponds to on-hook pattern on line. Fo…	column	milliseconds Unsigned32	`.1.3.6.1.4.1.9.9.314.1.3.3.1.2`
ccasLSTClearFwdTimer This object specifies the value of the timer that the GW will start at the request of the controlling application such as MGC for receipt of the clear forward signal on the lin…	column	milliseconds Unsigned32	`.1.3.6.1.4.1.9.9.314.1.3.3.1.3`
ccasLSTClearBwdTimer This object specifies the value of the timer that the GW will start at the request of the controlling application such as MGC for receipt of the clear backward signal. This obj…	column	milliseconds Unsigned32	`.1.3.6.1.4.1.9.9.314.1.3.3.1.4`
ccasLSTReleaseGuardTimer This object specifies the delay between reception of the clear forward signal and the sending of the idle signal. Upon reception of the clear forward signal, GW starts the rel…	column	millliseconds Unsigned32	`.1.3.6.1.4.1.9.9.314.1.3.3.1.5`
ccasLSTCASGlareTimer This object specifies the maximum amount of time MG will wait for other end to back out when glare occurs on a DS0 line. Change in incoming off-hook signal to on-hook signal …	column	milliseconds Unsigned32	`.1.3.6.1.4.1.9.9.314.1.3.3.1.6`
ccasLSTAnswerMeterDelayTimer The object specifies the delay between generation of the answer signal and the generation of the meter signal. The GW will start this timer after having sent the line answer sig…	column	milliseconds Unsigned32	`.1.3.6.1.4.1.9.9.314.1.3.3.1.7`
ccasLSTSeizeAckRspTimer This object specifies the maximum amount of time MG will wait for reception of seize ack signal. Seize Ack signal is expected in response of seize signal. This object is applied …	column	milliseconds Unsigned32	`.1.3.6.1.4.1.9.9.314.1.3.3.1.9`