aTPCEnable
CAMBIUM-PTP800-MIB ·
.1.3.6.1.4.1.17713.8.5.15
Object
scalar
Enumeration
Enables Automatic Transmitter Power Control (ATPC). NOTE: Use of ATPC is mandatory in some regions. When ATPC is enabled, the transmit power is dynamically adjusted to optimize link performance. The transmit power will always be adjusted within the constraints set by Maximum Transmit Power. When ATPC is disabled, the transmit power will be fixed at the level set by Maximum Transmit Power. When adaptive modulation is enabled, this setting can limit the capacity of the system by capping the modulation to a mode which is consistent with the configured Maximum Transmit Power.
Context
- MIB
- CAMBIUM-PTP800-MIB
- OID
.1.3.6.1.4.1.17713.8.5.15- Type
- scalar
- Access
- readonly
- Status
- current
- Parent
- configuration
- Siblings
- 21
Syntax
Enumeration
Values & Constraints
Enumerated Values
0 | disabled |
1 | enabled |
Related Objects
Sibling Objects
| Object | Type | Syntax | OID |
|---|---|---|---|
| iPv4Address Internet protocol (IPv4) address. This address is used
by the family of Internet protocols to uniquely identify
the unit on a network. | scalar | SNMPv2-SMIIpAddress | .1.3.6.1.4.1.17713.8.5.1 |
| remoteIPAddress IP Address of the peer wireless unit | scalar | SNMPv2-SMIIpAddress | .1.3.6.1.4.1.17713.8.5.12 |
| remoteMACAddress MAC Address of the peer wireless unit | scalar | OctetString | .1.3.6.1.4.1.17713.8.5.13 |
| enableTransmission Permits the transmitter to radiate. Once the unit is
installed and configured, use this to enable the
transmitter | scalar | Enumeration | .1.3.6.1.4.1.17713.8.5.14 |
| iFCableLength IF Cable Length in cm - please refer to the user manual
for more information on the recommended cable type. | scalar | Integer32 | .1.3.6.1.4.1.17713.8.5.16 |
| linkName Name of the PTP link allocated by the System
Administrator. Used to establish a connection with the
correct PTP wireless unit at the other end of the link.
NOTE: The link name … | scalar | OctetString | .1.3.6.1.4.1.17713.8.5.17 |
| siteName This field is allocated by the system administrator and
contains a description of the site name together with any
additional notes | scalar | OctetString | .1.3.6.1.4.1.17713.8.5.18 |
| diverseAntennaGain Diverse Antenna Receive Gain. Expressed in 10ths of
dBi. | scalar | Integer32 | .1.3.6.1.4.1.17713.8.5.19 |
| subnetMask A subnet allows the flow of network traffic between
hosts to be segregated based on a network configuration.
By organizing hosts into logical groups, subnetting can
improve net… | scalar | SNMPv2-SMIIpAddress | .1.3.6.1.4.1.17713.8.5.2 |
| diverseRfFeederLoss Insertion loss of the microwave connection between the
RFU and the diverse antenna. Expressed in 10ths of dB. | scalar | Integer32 | .1.3.6.1.4.1.17713.8.5.20 |
| iPv6Address Internet protocol (IPv6) address. This address is used
by the family of Internet protocols to uniquely identify
the unit on a network. | scalar | OctetString | .1.3.6.1.4.1.17713.8.5.21 |
| iPVersion IP protocol selection. Choice of IPv4, IPv6 or Dual. | scalar | Enumeration | .1.3.6.1.4.1.17713.8.5.22 |
| iPv6AutoConfiguredLinkLocalAddress The auto configured link local IPv6 address | scalar | OctetString | .1.3.6.1.4.1.17713.8.5.23 |
| iPv6PrefixLength IPv6 prefix length | scalar | Integer32 | .1.3.6.1.4.1.17713.8.5.24 |
| iPv6GatewayAddress The IPv6 address of a device on the current network that
is currently acting as an IPv6 network gateway. A gateway
acts as an entrance / exit to packets from / to other
network… | scalar | OctetString | .1.3.6.1.4.1.17713.8.5.25 |
| remoteInternetAddressType The type of Internet address specified by the associated
remoteInternetAddressType. | scalar | Enumeration | .1.3.6.1.4.1.17713.8.5.26 |
| remoteInternetAddress INET address used to identify the peer wireless unit | scalar | INET-ADDRESS-MIBInetAddress | .1.3.6.1.4.1.17713.8.5.27 |
| gatewayIPAddress The IPv4 address of a device on the current network that
acts as an IPv4 network gateway. A gateway acts as an
entrance / exit to packets from / to other networks. | scalar | SNMPv2-SMIIpAddress | .1.3.6.1.4.1.17713.8.5.3 |
| maximumTransmitPower Maximum transmit power the wireless unit is permitted to
use when establishing and maintaining the wireless link,
expressed in tenths of a dBm. Note that when an IRFU is
connec… | scalar | Integer32 | .1.3.6.1.4.1.17713.8.5.6 |
| antennaGain Antenna Gain. Expressed in 10ths of dBi. | scalar | Integer32 | .1.3.6.1.4.1.17713.8.5.7 |
| rFFeederLoss Insertion loss of the microwave connection between the
RFU and the antenna. The feeder loss should be 0 dB for
the standard 1 + 0 direct mount configuration. Expressed
in 10ths… | scalar | Integer32 | .1.3.6.1.4.1.17713.8.5.8 |