fsMplsFrrRevertiveMode
ARICENT-MPLS-FRR-MIB ·
.1.3.6.1.4.1.2076.13.3.1.10
Object
scalar
r/w
Bits
Global revertive mode: The head-end LSR of each tunnel is
responsible for reoptimizing the TE LSPs that used the failed
resource. There are several potential reoptimization triggers:
RSVP error messages, inspection of OSPF LSAs or ISIS LSPs, and
timers. Note that this re-optimization process may proceed as
soon as the failure is detected. It is not tied to the
restoration of the failed resource.
Local revertive mode: Upon detecting that the resource is
restored, the PLR re-signals each of the TE LSPs that used to be
routed over the restored resource. Every TE LSP successfully
re-signaled along the restored resource is switched back.
Context
- MIB
- ARICENT-MPLS-FRR-MIB
- OID
.1.3.6.1.4.1.2076.13.3.1.10- Type
- scalar
- Access
- readwrite
- Status
- current
- Parent
- fsMplsFrrScalars
- Siblings
- 15
Syntax
Bits
Values & Constraints
Enumerated Values
0 | global |
1 | local |
Related Objects
Sibling Objects
| Object | Type | Syntax | OID |
|---|---|---|---|
| fsMplsFrrDetourIncoming The number of detour LSPs entering the device
(greater than or equal to 0) if fsMplsFrrConstProtectionMethod
is set to oneToOneBackup(1), or -1 if
fsMplsFrrConstProtectionMethod i… | scalar | Integer32 | .1.3.6.1.4.1.2076.13.3.1.1 |
| fsMplsFrrDetourMergingEnabled Enables or disables FRR Detour Merging.
Detour Merging is enabled by default. This is applicable for
One-to-One Backup Method only. | scalar | SNMPv2-TCTruthValue | .1.3.6.1.4.1.2076.13.3.1.11 |
| fsMplsFrrDetourEnabled Enables or disables FRR Detour object handling.
Detour object handling is enabled by default.
This is applicable for One-to-One Backup Method only. | scalar | SNMPv2-TCTruthValue | .1.3.6.1.4.1.2076.13.3.1.12 |
| fsMplsFrrCspfRetryInterval The value of the CSPF retry interval, which is used to
periodically send the CSPF calculation trigger until
the valid CSPF calculation done. It is specified in
milli seconds. | scalar | SNMPv2-TCTimeInterval | .1.3.6.1.4.1.2076.13.3.1.13 |
| fsMplsFrrCspfRetryCount This indicates the value of the CSPF retry count. | scalar | SNMPv2-SMIGauge32 | .1.3.6.1.4.1.2076.13.3.1.14 |
| fsMplsFrrNotifsEnabled Enables or disables FRR notifications defined in this
MIB module. Notifications are disabled by default. | scalar | SNMPv2-TCTruthValue | .1.3.6.1.4.1.2076.13.3.1.15 |
| fsMplsFrrMakeAfterBreakEnabled Enables or disables Make after break support for FRR
Protected LSP. It is disabled by default. | scalar | SNMPv2-TCTruthValue | .1.3.6.1.4.1.2076.13.3.1.16 |
| fsMplsFrrDetourOutgoing The number of detour LSPs leaving the device (greater
than or equal to 0) if fsMplsFrrConstProtectionMethod
is set to oneToOneBackup(1), or -1 if
fsMplsFrrConstProtectionMethod is… | scalar | Integer32 | .1.3.6.1.4.1.2076.13.3.1.2 |
| fsMplsFrrDetourOriginating The number of detour LSPs originating at this PLR (greater
than or equal to 0) if fsMplsFrrConstProtectionMethod
is set to oneToOneBackup(1). This object MUST
return -1 if the fs… | scalar | Integer32 | .1.3.6.1.4.1.2076.13.3.1.3 |
| fsMplsFrrSwitchover The number of tunnel instances for which this LSR
is the ingress that are currently using a detour
or bypass LSP to reach their egress. | scalar | SNMPv2-SMIUnsigned32 | .1.3.6.1.4.1.2076.13.3.1.4 |
| fsMplsFrrConfIfs Indicates the number of MPLS interfaces configured for
protection by the FRR feature if
fsMplsFrrConstProtectionMethod
is set to facilityBackup(2), otherwise this value
MUST retur… | scalar | Integer32 | .1.3.6.1.4.1.2076.13.3.1.5 |
| fsMplsFrrActProtectedIfs Indicates the number of interfaces currently being
protected by the FRR feature if
fsMplsFrrConstProtectionMethod is set to
facilityBackup(2), otherwise this value should return
0… | scalar | SNMPv2-SMIUnsigned32 | .1.3.6.1.4.1.2076.13.3.1.6 |
| fsMplsFrrConfProtectionTuns Indicates the number of bypass tunnels configured to
protect TE tunnels on this LSR using the FRR feature
if fsMplsFrrConstProtectionMethod is set to
facilityBackup(2), otherwise … | scalar | SNMPv2-SMIUnsigned32 | .1.3.6.1.4.1.2076.13.3.1.7 |
| fsMplsFrrActProtectionTuns Indicates the number of bypass tunnels indicated in
mplsFrrConfProtectionTuns whose operStatus
is up(1) indicating that they are currently protecting
TE tunnels on this LSR using … | scalar | SNMPv2-SMIUnsigned32 | .1.3.6.1.4.1.2076.13.3.1.8 |
| fsMplsFrrActProtectedLSPs Indicates the number of LSPs currently protected by
the FRR feature where this device acts as the PLR
for those LSPs. If fsMplsFrrConstProtectionMethod
is set to facilityBackup(2)… | scalar | SNMPv2-SMIUnsigned32 | .1.3.6.1.4.1.2076.13.3.1.9 |