aluXdslLineFailureDS

ALU-PORT-MIB · .1.3.6.1.4.1.6527.6.1.2.2.2.4.12.1.21
MIB view Table view

Object

column SNMPv2-SMIUnsigned32 
It is bit mask giving the set of current active failure
on the downstream line. The value is retrieved from BCM6519.
              
A failure is declared when the corresponding defect is active for
more than 2.5 (+ or - 0.5) sec. A failure is cleared when the
corresponding defect is off for at least 10.5 (+ or - 0.5) sec. The
bit index and corresponding failures are:
Bit[1]: Set when unavailable time is counted
Bit[2]: Set when the modem is not in the RUNNING_SHOWTIME state
Bit[6]: Loss of ATM cell or PTM packet delineation, bearer B0
Bit[7]: Loss of ATM cell or PTM packet delineation, bearer B1
Bit[12]: Loss of signal
Bit[13]: Loss of frame
Bit[14]: No ATM cell or PTM packet delineation, bearer B0
Bit[15]: No ATM cell or PTM packet delineation, bearer B1
Bit[18]: Loss of power
Bit[24]: CONFIG_ERROR
Bit[25]: HIGH_BIT_RATE
Bit[26]: COMM_PROBLEM
Bit[27]: NO_PEER_DETECTED
Bit[28]: Set when the loss of margin failure is set (when the SNR
         margin drops below the the minimum SNR margin for more than 20
         consective seconds).
Bit[29]: Set when the line leaves Showtime because the L3 state is
         requested by the CO or CPE.

Context

MIB
ALU-PORT-MIB
OID
.1.3.6.1.4.1.6527.6.1.2.2.2.4.12.1.21
Type
column
Access
readonly
Status
current
Parent
aluXdslLineEntry
Table
aluXdslLineTable
Siblings
23

Syntax

SNMPv2-SMIUnsigned32
Source
SNMPv2-SMIUnsigned32
Base type
Unsigned32

Values & Constraints

Type Constraints
range: 0..4294967295

Related Objects

Sibling Objects
ObjectTypeSyntaxOID
aluXdslLineID
When aluXdslLineID is used in conjunction with tmnxChassisIndex and tmnxPortPortID, it uniquely identifies a specified physical XDSL line in the managed system.
columnUnsigned32.1.3.6.1.4.1.6527.6.1.2.2.2.4.12.1.1
aluXdslLineOutputPowerUS
It indicates the upstream transmit power (expressed in tenth of dBm's). It is retrieved from BCM6519.
columnInteger32.1.3.6.1.4.1.6527.6.1.2.2.2.4.12.1.10
aluXdslLineRefPsdUS
It indicates the upstream ref psd = nomial PSD - power cutback (expressed in tenths of dB's). It applies to ADSL ptotocols only. It is retrieved from BCM6519.
columnInteger32.1.3.6.1.4.1.6527.6.1.2.2.2.4.12.1.11
aluXdslLineLoopDelayUS
It indicates the current loop group delay, only measured in VDSL. US: delay as measured on RMSG1 = actual loop delay DS: delay as measured on R-P-TRAINING1 = residual after applic…
columnInteger32.1.3.6.1.4.1.6527.6.1.2.2.2.4.12.1.12
aluXdslLineFailureUS
It is bit mask giving the set of current active failure on the upstream line. The value is retrieved from BCM6519. A failure is declared when the corresponding defe…
columnSNMPv2-SMIUnsigned32.1.3.6.1.4.1.6527.6.1.2.2.2.4.12.1.13
aluXdslLineB0DelayUS
It indicates the current delay incurred on the upstream B0 latency path, expressed in milliseconds. The value is retrieved from BCM6519.
columnUnsigned32.1.3.6.1.4.1.6527.6.1.2.2.2.4.12.1.14
aluXdslLineB0InpUS
It indicates the current INP protection achived on the upstream B0 latency path, Unit is 1/2 symbol. The value is retrieved from BCM6519.
columnUnsigned32.1.3.6.1.4.1.6527.6.1.2.2.2.4.12.1.15
aluXdslLineBitRateDS
It indicates the downstream line bit rate, unit is 1Kpbs. It is retrieved from BCM6519.
columnSNMPv2-SMIUnsigned32.1.3.6.1.4.1.6527.6.1.2.2.2.4.12.1.16
aluXdslLineSnrMarginDS
It indicates the downstream SNR margin (expressed in tenth of dB's). It is retrieved from BCM6519.
columnInteger32.1.3.6.1.4.1.6527.6.1.2.2.2.4.12.1.17
aluXdslLineOutputPowerDS
It indicates the downstream transmit power (expressed in tenth of dBm's). It is retrieved from BCM6519.
columnInteger32.1.3.6.1.4.1.6527.6.1.2.2.2.4.12.1.18
aluXdslLineRefPsdDS
It indicates the downstream ref psd = nomial PSD - power cutback (expressed in tenths of dB's). It applies to ADSL ptotocols only. It is retrieved from BCM6519.
columnInteger32.1.3.6.1.4.1.6527.6.1.2.2.2.4.12.1.19
aluXdslLineOperState
It indicates the operational state of the XDSL line. The 'up' state indicates that the DSL line can be used for passing traffic. For 'ptm' TPS-TC XDSL line, the alu…
columnEnumeration.1.3.6.1.4.1.6527.6.1.2.2.2.4.12.1.2
aluXdslLineLoopDelayDS
It indicates the current loop group delay, only measured in VDSL. US: delay as measured on RMSG1 = actual loop delay DS: delay as measured on R-P-TRAINING1 = residual after applic…
columnInteger32.1.3.6.1.4.1.6527.6.1.2.2.2.4.12.1.20
aluXdslLineB0DelayDS
It indicates the current delay incurred on the downstream B0 latency path, expressed in milliseconds. The value is retrieved from BCM6519.
columnUnsigned32.1.3.6.1.4.1.6527.6.1.2.2.2.4.12.1.22
aluXdslLineB0InpDS
It indicates the current INP protection achived on the downstream B0 latency path, Unit is 1/2 symbol. The value is retrieved from BCM6519.
columnUnsigned32.1.3.6.1.4.1.6527.6.1.2.2.2.4.12.1.23
aluXdslLineAdminState
It indicates the desired administrative status of this DSL Line
columnAluDslAdminState.1.3.6.1.4.1.6527.6.1.2.2.2.4.12.1.24
aluXdslLineState
It indicates the state of the XDSL line retrieved from BCM6519.
columnEnumeration.1.3.6.1.4.1.6527.6.1.2.2.2.4.12.1.3
aluXdslLineProtocol
It indicates the protocol of the XDSL line retrieved from BCM6519.
columnEnumeration.1.3.6.1.4.1.6527.6.1.2.2.2.4.12.1.4
aluXdslLineVdslProfile
It indicates the VDSL profile of the XDSL line retrieved from BCM6519.
columnEnumeration.1.3.6.1.4.1.6527.6.1.2.2.2.4.12.1.5
aluXdslLineTpsTcType
It indicates the TPS-TC of the XDSL line retrieved from BCM6519.
columnAluDslTpsTcType.1.3.6.1.4.1.6527.6.1.2.2.2.4.12.1.6
aluXdslLineInBondingGroup
It indicates if the line belongs to bonding group on the DSL Port
columnSNMPv2-TCTruthValue.1.3.6.1.4.1.6527.6.1.2.2.2.4.12.1.7
aluXdslLineBitRateUS
It indicates the upstream line bit rate, unit is 1Kpbs. It is retrieved from BCM6519.
columnSNMPv2-SMIUnsigned32.1.3.6.1.4.1.6527.6.1.2.2.2.4.12.1.8
aluXdslLineSnrMarginUS
It indicates the upstream SNR margin (expressed in tenth of dB's). It is retrieved from BCM6519.
columnInteger32.1.3.6.1.4.1.6527.6.1.2.2.2.4.12.1.9