atmNteConfOamIfAisRdi

This parameter controls the generation of F4/F5 
AIS and RDI due to lower order problems such as physical
layer problems.
               
For AIS: Defines if F4/F5 AIS cell is transmitted due
 to problems such as physical layer alarm or F4/F5 defect. 
 This is applicable for all  ports .
 off - Problems in this port  will not trigger F4/F5 AIS
       transmition to the ajacent port (e.g. from USER to 
       NETWORK) of a VPC/VCC.
 on  - Problems in this port will trigger F4/F5 AIS 
       transmition to the ajacent port (e.g. from USER 
       to NETWORK) of a VPC/VCC.                 
               
For RDI: Defines if F4/F5 RDI cell will be transmitted due to
 physical layer problems in that port (in addition to
 F4/F5 RDI cells transmitted due to ATM layer problems).
 For example, If it is enabled for Network port, then
 physical layer defect will initiate the transmission
 of F4/F5 RDI cell back to the trunk.
              
 The type of F4/F5 (Segment or End-to-End) is according
 to the configuration of the VPC/VCC.

MIB

ACE202-MIB

OID

.1.3.6.1.4.1.164.12.3.1.1.9.4.1.1

Type

column

Access

readwrite

Status

current

Parent

atmNteConfOamIfEntry

Table

atmNteConfOamIfTable