PDN-ETHER-MIB Table View

Table-centric layout grouping table, row, and column objects.

Standard view Table view
Tables
3
Rows
3
Columns
7

pdnPortConfigEthernetTable

table
.1.3.6.1.4.1.1795.2.24.2.18.1.1.1 · 1 row entry · 5 columns
Open in standard view 
A Table that contains information about 
the Ethernet port configuration
pdnPortConfigEthernetEntry entry .1.3.6.1.4.1.1795.2.24.2.18.1.1.1.1
An entry that contains configuration
information about an ethernet Port
Indexes
Column Syntax OID
pdnPortConfigEthernetDuplexMode
This object is used to enable or Disable
Duplex Mode on an ethernet Port. This object
can not be enabled if the auto-negotiate
mode is enabled
PDN-TCSwitchStater/w
Textual Convention: PDN-TCSwitchState Enumeration
Type Values:
1enabled
2disabled
 .1.3.6.1.4.1.1795.2.24.2.18.1.1.1.1.1
pdnPortConfigEthernetManageType
This object is used to Enable or
Disable Inband or Outband Management.
PDN-TCManagementTyper/w
Textual Convention: PDN-TCManagementType Enumeration
Type Values:
1inband
2outband
 .1.3.6.1.4.1.1795.2.24.2.18.1.1.1.1.2
pdnPortConfigEthernetResetState
This object is used to reset the ethernet port.
PDN-TCResetStatesr/w
Textual Convention: PDN-TCResetStates Enumeration
Type Values:
1noOp
2reset
3resetToFactoryDefaults
4resetToNewActiveConfig
 .1.3.6.1.4.1.1795.2.24.2.18.1.1.1.1.3
pdnPortConfigEthernetAutoNegotiate
This object is used to enable or disable
the auto-negotiate mode. Enabling this
mode will disable selection of the speed
and/or full duplex mode.
PDN-TCSwitchStater/w
Textual Convention: PDN-TCSwitchState Enumeration
Type Values:
1enabled
2disabled
 .1.3.6.1.4.1.1795.2.24.2.18.1.1.1.1.4
pdnPortConfigEthernetSpeed
This object corresponds to the speed of
the ethernet port. This object can not be
set if the auto-negotiate mode is enabled.
Enumerationr/w
Enumerated Values:
1tenBaseT
2hundredBaseT
 .1.3.6.1.4.1.1795.2.24.2.18.1.1.1.1.5

pdnPortConfigMauExtTable

table
.1.3.6.1.4.1.1795.2.24.2.18.1.3.1 · 1 row entry · 1 columns
Open in standard view 
A Table that contains configuration information about 
the Ethernet port configuration and it extends standard
 MAU table from RFC2668.
pdnPortConfigMauExtEntry entry .1.3.6.1.4.1.1795.2.24.2.18.1.3.1.1
An entry that contains configuration
information about an ethernet Port
Indexes
No indexes recorded
Column Syntax OID
pdnPortConfigXover
This object is used to configure
if crossover or straightthrough cable is
used on ethernet interface if the interface
is not set for autonegotiontion.
Enumerationr/w
Enumerated Values:
1mdi
2mdix
 .1.3.6.1.4.1.1795.2.24.2.18.1.3.1.1.1

pdnIfJackTable

table
.1.3.6.1.4.1.1795.2.24.2.18.1.4.1 · 1 row entry · 1 columns
Open in standard view 
This table conceptually extends the ifJackTable
but not as an augmentation. See the note above.
pdnIfJackEntry entry .1.3.6.1.4.1.1795.2.24.2.18.1.4.1.1
An entry that contains configuration information
about a jack.
Indexes
MAU-MIBifMauIfIndex MAU-MIBifMauIndex MAU-MIBifJackIndex
Column Syntax OID
pdnActiveJack
This object allows the jack type to be configured or a
priority to be set. This applies to Ethernet interfaces
that may support more than one type of jack on an inter-
face and only one jack is valid at a time. Conside…
Enumerationr/w
Enumerated Values:
1fiber
2rj45
3auto
 .1.3.6.1.4.1.1795.2.24.2.18.1.4.1.1.1