Trap of Alarm: Loss of signal.

Trap of Alarm: Regenerator section performance over threshold.

Trap of Alarm: Loss of timing input.

Trap of Alarm: Synchronous Source Degrade.

Trap of Alarm: E1/T1 interface loss of analog signal.

Trap of Alarm: Loss of synchronization source level.

Trap of Alarm: Fan failure.

Trap of Alarm: 2M Line Loss Of Signal.

Trap of Alarm: 2M up signal alarm indication.

Trap of Alarm: Board not in position alarm.

Trap of Alarm: Regenerator section (B1) excessive errors.

Trap of Alarm:Protection switch indication

Trap of Alarm: Wrong board type.

Trap of Alarm: The ETHOAM_RMT_LOOP is an alarm indicating the remote loopback of point-to-point Ethernet OAM. This alarm only occurs to the port with the point-to-point OAM protocol enabled. If the port is able to respond to loopback, it enters the loopback response state and reports the loopback response alarm after it receives the remote loopback enabling command sent by the opposite OAM port. The loopback initiator reports the loopback initiating alarm. If the port receives the loopback disabling command, it exits the loopback response state and ends the loopback response alarm. The loopback initiator end also ends the loopback initiating alarm.

Trap of Alarm: The EthOamRmtSd is an alarm indicating the remote SD of point-to-point Ethernet OAM. When the port with the OAM protocol enabled receives the link event message from the opposite end which indicates that the remote Ethernet performance degraded, this alarm occurs.

Trap of Alarm: The EthOamRmtCritFault is an alarm indicating that a critical fault occurs to the remote end of point-to-point Ethernet OAM. When the port with the OAM protocol enabled receives the OAM message that contains critical fault information from the opposite end, this alarm occurs.

Trap of Alarm: EthOamDiscoverFail is an alarm indicating the point-to-point Ethernet OAM discovery failure. When the OAM protocol is enabled at the port of a board and the negotiation with the opposite equipment fails, this alarm occurs.

Trap of Alarm: 1.5M down signal alarm indication.

Trap of Alarm: Continuity Check Message Loss

Trap of Alarm: Maintenance Identify Conflict

Trap of Alarm: The LPT_RFI is a remote failure indication alarm of link state pass through. This alarm occurs when the link state pass through (LPT) detects the failure of the remote port or the LPT service network.

Trap of Alarm: Port inflow over the limit

Trap of Alarm: Critical relay alarm.

Trap of Alarm: Major relay alarm.

Trap of Alarm: Minor relay alarm.

Trap of Alarm: Relay alarm warning.

Trap of Alarm: Power failure

Trap of Alarm: Remote defect alarm of ethernet port.

Trap of Alarm: Local defect alarm of ethernet port.

Trap of Alarm: Hardware error.

Trap of Alarm:No e-label

Trap of Alarm: the NE and the SYSLOG server have an abnormal connection or session in the TCP mode.

Trap of Alarm: Microwave remote defect indication.

Trap of Alarm: Forward Error Correction code uncorrectable.

Trap of Alarm: Abnormal IF power received by ODU.

Trap of Alarm:XCS protection switching indication

Trap of Alarm: Wrong device type.

Trap of Alarm: CF Card offline.

Trap of Alarm: CF Card Failed.

Trap of Alarm:The CFCARD_W_R_DISABLED is an alarm indicating that reading and writing the CF card are disabled.

Trap of Alarm:Loss of PRBS(Pseudo-Random Binary Sequence) signal

Trap of Alarm: Ethernet OAM(802.3ah) self loop alarm

Trap of Alarm: Ethernet OAM(802.3ah)self loop alarm

Trap of Alarm: Port aggregation failure

Trap of Alarm: VCTRUNK aggregation failure

Trap of Alarm: Patch Deactivation Timeout

Trap of Alarm: Patch Activation Timeout

Trap of Alarm:CF card capacity fully used

Trap of Alarm: No traffic at Ethernet port.

Trap of Alarm: Working mode mismatch at remote FE port.

Trap of Alarm: Patch package file error.

Trap of Alarm: State of auto-synchronization disabled.

Trap of Alarm: Failure of network interface connection.

Trap of Alarm: An alarm indicating that the number of FCS errors received over the Ethernet interface crosses the threshold.

Trap of Alarm: An alarm indicating that FCS errors received over the Ethernet interface crosses the lower(degraded) threshold.

Trap of Alarm: Loss Packets Excess.

Trap of Alarm: Misorder Dropped Packets Excess.

Trap of Alarm: Stray Dropped Packets Excess.

Trap of Alarm: Malformed Packets Excess alarm.

Trap of Alarm: Jitter buffer underrun alarm.

Trap of Alarm: Jitter buffer overrun alarm.

Trap of Alarm: Jitter buffer overrun alarm.

ML-PPP group failure.

Delay alarm.

LCP negotiation failure.

NCP negotiation alarm.

Trap of Alarm: Mac fdb of elan used up.

Trap of Alarm: Lost of Continuity Check.

Trap of Alarm: Lost of Continuity Check.

Trap of Alarm: Loss of Connectivity Verification defect.

Trap of Alarm: Receiving excess rate of CV.

Trap of Alarm: Trail Termination Source Identifier Mismatch defect.

Trap of Alarm: Trail Termination Source Identifier Mismerge defect.

Trap of Alarm: Unknown defect in the MPLS network.

Trap of Alarm: Backward Defect Indicator.

Trap of Alarm: Forward Defect Indicator.

Trap of Alarm: Signal Degrade.

Trap of Alarm: Signal Fail.

Trap of Alarm: Trap of Alarm: Misconnection alarm

Trap of Alarm: Errored frame alarm

Trap of Alarm: Loss of continuity

Trap of Alarm: Remote Defect Indication

Trap of Alarm: Discovery failure

Trap of Alarm: Remote failure

Trap of Alarm: Remote link event

Trap of Alarm: Loopback alarm

Trap of Alarm: Mismatch of APS Protection Type.

Trap of Alarm: Working/Protection mismatch.

Trap of Alarm: Protection switching incomplete.

Trap of Alarm: APS Frame Lost.

Trap of Alarm: LAG member unavailable

Trap of Alarm: LAG unavailable

Trap of Alarm: IMA group Local Edge fail.

Trap of Alarm: IMA group Remote Edge fail.

Trap of Alarm: pw drop packets crosses the threshold.

Trap of Alarm: pw drop packets crosses the threshold.

Trap of Alarm: Loss of OSC interface input optical power.

Trap of Alarm: The capacity exceeds the limitation specified by the license.

Trap of Alarm: Loss of license file.

Trap of Alarm: Loss of XPIC signal.

Trap of Alarm: Open circuit of IF cable.

Trap of Alarm: The IF mode is not supported.

Trap of Alarm: N+1 protection switching indication.

Trap of Alarm: N+1 automatic protection switching failure indication.

Trap of Alarm: N+1 APS protocol manually stopped.

Trap of Alarm: The module type that is set by the user does not match the actual module type.

Trap of Alarm: Microwave protection switching alarm.

Trap of Alarm: Microwave link excessive errors.

Trap of Alarm: Microwave link signal degraded.

Trap of Alarm: Patch inconsistency after the SCC board is replaced.

Alarm storm. Certain alarms on the SCC board may be lost when the alarm queue is full. This alarm indicates that the alarm module is in the alarm storm state.

Trap of Alarm: 1588ACR Lock Failure.

Trap of Alarm:The Ethernet linear protection switching (ELPS) configuration at both ends mismatches.

Circuit failure result in no power output or turnoff the power to protect the circuit.

Trap of Alarm: The transmission delay of the IMA link exceeds the threshold.

Trap of Alarm: LAN Loss of carrier signal.

Trap of Alarm: Automatic link down of Ethernet port.

Trap of Alarm: Time having no source to follow.

Trap of Alarm: Time source loss of signal.

Trap of Alarm: The external clock source is lost.

Trap of Alarm:Misconnected to IFH2

Trap of Alarm: The fading margin is insufficient.

Trap of Alarm: Tunnel Down.

Trap of Alarm: ISIS Neighbor Authentication err.

Trap of Alarm: RSVP Neighbor Down.

Trap of Alarm: RSVP Neighbor Authentication err.

Trap of Alarm: 1.5M up signal alarm indication.

Trap of Alarm:AIS of E1 frame

Trap of Alarm:Loss of E1 frame

Trap of Alarm: The mac of static arp is mismatched.

Trap of Alarm: The default user's default password must be changed to reduce risks.

Trap of Alarm: Indicates that a node on the EPRS ring is faulty.

Trap of Alarm: Number of TCP connections between NEs running the automatically extended ECC protocol exceeding the system limit .

Trap of Alarm: AM modulation downshift.

Trap of Alarm: More than one RPL_OWNER alarm

Trap of Alarm: The ODU threshold exceeds the threshold.

Trap of Alarm:Number of lost packets over the threshold in a certain period

Trap of Alarm:Number of disorder packets over the threshold in a certain period

Trap of Alarm: Number of unknown cells over the threshold in a certain period.

Trap of Alarm:Remote loss packet of CES PW

Trap of Alarm: The opposite station has a remote alarm indication.

Trap of Alarm: The opposite station has an attachment circuit fault.

Trap of Alarm: Tunnel OAM protocol negotiation failure.

Trap of Alarm: CPU BUSY.

Trap of Alarm: Pw loss of connectivity verification.

Trap of Alarm: Excessive pw terminal source identifications (TTSIs) received.

Trap of Alarm: Mismatched pw terminal source identifications (TTSIs).

Trap of Alarm: Incorrect merging of PW terminal source identifications (TTSIs).

Trap of Alarm: Unknown pw defect in the MPLS network.

Trap of Alarm: Pw backward defect indication.

Trap of Alarm: Pw signal degrade.

Trap of Alarm: Pw signal fail.

Trap of Alarm: Mismatch of APS Protection Types.

Trap of Alarm: Mismatch of APS working/protection paths.

Trap of Alarm: Protection switching failure.

Trap of Alarm: APS frame lost.

Trap of Alarm:MCAPS APSID MisMatch

Trap of Alarm:MCAPS DNI PW MisMatch

Trap of Alarm: The transmit clock modes of an IMA group are inconsistent at both ends.

When no traffic is received, this alarm is reported.

Trap of Alarm: Bandwidth inconsistency in the LAG group.

Trap of Alarm: DCN Size Over.

Trap of Alarm: The number of DCN OSPF neighbors excesses the  suggested threshold.

Trap of Alarm:MEM_OVER

Trap of Alarm:Loss of Connectivity Verification defect

Trap of Alarm:Configuration of MC-LAG Mismatch

Trap of Alarm: LPT closed access port.

Trap of Alarm: This alarm indicates that, in the protection group, the license capacity of the boards differs from each other.

Trap of Alarm: Fan aging.

Trap of Alarm: NTP Synchronization Failure.

Indicates a PW OAM protocol negotiation failure.

Trap of Alarm: No license file.

Trap of Alarm: License expiredLicense.

Trap of Alarm: The license has expired and is within the keepalive period of 60 days.

Trap of Alarm: K1K2 Mismatch.