NETBOTZ-MIB Table View

The module ID of the sensor module installed. Blank string indicates that no module is installed.

The type of sensor module installed. NONE=no module, AMP=AmpDetect module, TEMP=temperature sensor, DRY=dry contact sensor.

The label for the expansion port. Ports default to the label 'Extn', for port n.

The reading of the amperage probe, in milliamps.

The accumulated total of amp-seconds on the AmpDetect.

The UTC time (seconds since 1/1/1970) of the beginning of the accumulated total of amp-seconds on the AmpDetect.
Writing a value to this attribute resets the accumulated total amp-seconds and sets this time to the curre…

Amperage probe alarm enabled(1) or disabled(0).

The amperage probe minimum, from 0 to 30000 milliamps.

The amperage probe maximum, from 0 to 30000 milliamps.

The scaling factor used for the amperage probe to convert microvolts measured from the
Amp Detect into 10s of milliamps of current. Needs to be set based on the type of Amp Detect module installed.

The maximum RMS milliamps measureable by the AmpDetect.

The reading of the external temperature probe, in degrees F or degrees C (depends on netBotz-ismetric).

External temperature probe alarm enabled(1) or disabled(0).

The external temperature probe minimum, in degrees F or degrees C (depends on netBotz-ismetric).

The external temperature probe maximum, in degrees F or degrees C (depends on netBotz-ismetric).

The scaling factor used for the external temperature probe to convert microvolts measured from the
temperature sensor into degrees C. Needs to be set based on the type of temperature sensor module installed.

The offset used for the external temperature probe of microvolts measured from the
temperature sensor at zero degrees C. Needs to be set based on the type of temperature sensor module installed.

The minimum temperature measureable by the temperature sensor, in tenths of a degree C.
Needs to be set based on the type of temperature sensor module installed.

The maximum temperature measureable by the temperature sensor, in tenths of a degree C.
Needs to be set based on the type of temperature sensor module installed.

The current value of the external dry contact sensor: 0=Open, 1=Closed, -1=N/A

The value to generate alarms on for the external dry contact sensor: 0=Open, 1=Closed

External dry contact sensor alarm enabled(1) or disabled(0).

The sensor name/label for the dry contact sensor

The sensor name/label for the open(0) state for the dry contact sensor

The sensor name/label for the closed(0) state for the dry contact sensor

The minimum number of milliseconds that the dry contact sensor
must read closed before the state is changed from open to closed.

The minimum number of milliseconds that the dry contact sensor
must read openbefore the state is changed from closed to open.

The type of alert response for the dry contact sensor: ALERT=e-mail with no
pictures, CAMERA=e-mail with pictures from camera.

The reading of the external humidity probe, in percent.

External humidity probe alarm enabled(1) or disabled(0).

The external humidity probe minimum, in percent.

The external humidity probe maximum, in percent.

The scaling factor used for the external humidity probe to convert microvolts measured from the
humidity sensor into percent. Needs to be set based on the type of humidity sensor module installed.

The offset used for the external humidity probe of microvolts measured from the
humidity sensor at zero percent. Needs to be set based on the type of humidity sensor module installed.

The minimum humidity measureable by the humidity sensor, in percent.
Needs to be set based on the type of humidity sensor module installed.

The maximum humidity measureable by the humidity sensor, in percent.
Needs to be set based on the type of humidity sensor module installed.