portInstalled trap send when portInstallStatus is enabled.

Fan removed trap when fan was removed.

clockModuleInstalled trap send when sleClockModuleInstallStatus is installed.

clockModuleRemoved trap send when sleClockModuleInstallStatus is removed.

clockModuleInitOk trap send when sleClockModuleInitStatus is ok.

clockModuleInitFail trap send when sleClockModuleInitStatus is failure.

This trap indicates the interface admin up.

Broadcast packet over trap when Rx broadcast packet is over the given limit.

This trap indicates the interface admin down.

This trap indicates the power monitoring detects voltage change of slot.

This trap indicates the ntp connection is lost.

This trap indicates the fan speed is under the threshold.

This trap indicates the fan speed is over the threshold.

This trap indicates the user fail to login.

This trap indicates that BFD session state is changed.

This trap indicate that slot Operation mode is changed.

This trap indicate that slot reference ntr is changed.

The cpuLoadoverThreshold trap is sentwhen cpuLoad is over the given limit.

Port Rx traffic over HighThreshold trap when port traffic is over the given limit.

Port Rx traffic fall under HighThreshold trap when port traffic falls below the given limit.

Port Tx traffic over HighThreshold trap when port traffic is over the given limit.

Port Tx traffic fall under HighThreshold trap when port traffic falls below the given limit.

This trap indicate that BFD reference ntr is changed.

This trap indicate that BFD reference ntr is changed.

This trap indicate that BFD reference ntr is changed.

This trap indicate that BFD reference ntr is changed.

This trap indicate that BFD reference ntr is changed.

The cpuLoadfallThreshold trap is sent when cpuLoad fall under the given limit.

DHCP User IP pool shortage when User's DHCPDISCOVER message arrive.

Port traffic over HighThreshold trap when port traffic is over the given limit.

ONU reports a Link Fault via the flag in the 802.3ah OAM header.No further information about the fault is available..

Loss of Signal is detected by the PHY device for OLT Network  interface, and PON interfaces on  the OLT and ONU.

Transmitted output does not match input, as reported by EPON optics

Transmitted output has a high error level, but not so high as to cause - Failure. Optionallyreported by EPON optical module..

One of the queues for the link has dropped frames due to becoming full

MAC address learning table is full, not in overwrite mode, and a new MAC address wasencountered

MPCP register request received for MAC that is registered and in-service

ONU does not respond to grants from the OLT

Excessive interval between MPCP gates.

Port traffic fall under HighThreshold trap when port traffic fall under the given limit.

OAM KeepaliveTimeout - OAM layer does not receive periodic messages from its peer

The link peer has failed to generate a new key message, or to switch to the new key, in the timeallotted by the key exchange timer for this link. Encryption remains in force using the old key, and the key exchange process continues.The alarm will clear when a new key is established.

OLT Network port fails to auto-negotiate with the peer (if auto-negotiation feature is enabled).

The link is currently in the loopback state

ONU reports Dying Gasp via that bit in 802.3ah OAM header

Power supply failure

Operating temperature range exceeded

ONU is configured to use external authentication device, and that device is not present

TemperatureOverThreshold Trap is sent when temperature is over the certain threshold.

Octets Transferred

Total frames transferred

Unicast frames transferred

Broadcast frames transferred

Multicast frames transferred

CRC-32 Errors

Undersize Frames

Oversize Frames

Collisions

SystemRestart Trap is sent when system is restarted by user.

64 Octet Frames

65-127 Octet Frames

128-255 Octet Frames

256-511 Octet Frames

512-1023 Octet Frames

1024-1518 Octet Frames

1519+ Octet Frames

Frames dropped

Octets dropped

Octets delayed

mfgdblocked Trap is sent when a certain mac address is denied by mac-flood-guard mechanism.

Octets granted

Octets granted but unused

Maximum Delay (units of 100usec)

CRC-8 (preamble) Errors

Line code errors

Pause Frames

Errored Frame Seconds

Errored Frame Period

Errored Frame Seconds Summary

portInstalled trap send when portInstallStatus is disabled.

mfgdblocked Trap is sent when a certain mac address is permitted again by mac-flood-guard mechanism.

Registered Onu Information

Deregistered Onu Information

S/W Watchdog Detect Error

S/W Watchdog Clear Error

S/W Watchdog Normal State

S/W Watchdog Abnormal State

Upgrade Completed Onu Informations

GPON Cable down event is detected

GPON Onu is auto-to-manual

This trap indicates the slot action event

ipConflict Trap is sent when a certain IP address is shared among different users.

This trap indicates the slot state is changed

No authenticated ONU

Duplicated ONU

Dying Gasp of GPON ONU

Found Rogue ONU.

Battery Event.

Battery Event is cleared.

This trap indicates state of ONU Port Operation.

This trap indicates GPON transceiver changed.

This trap indicates state of OLT Log Of Signal (on).

dhcpIllegalEntry trap is sent when illegal dhcp user is found.

This trap indicates state of OLT Log Of Signal (off).

This trap indicates state of OLT Log Of Signal for ONUi (on).

This trap indicates state of OLT Log Of Signal for ONUi (off).

This trap indicates Dying Gasp of GPON ONU (on).

This trap indicates Dying Gasp of GPON ONU (off).

This trap indicates slot error LED changed.

This trap indicates NMS connection type changed.

This trap indicates ONT OS upgrade status changes.

This trap indicates ONT BL upgrade status changes.

This trap indicates ONT port failed to detect Rx Power.

optionModuleInstalled Trap is sent when option Module was installed.

This trap indicates ONT port detected Rx Power.

This trap indicates the temperature of ONU is over high threshold.

This trap indicates the temperature of ONU falls under high threshold.

This trap indicates the temperature of ONU is over low threshold.

This trap indicates the temperature of ONU falls under low threshold.

This trap indicates the CPU-load of ONU is over threshold.

This trap indicates the CPU-load of ONU falls under threshold.

This trap indicates the memory-utilization of ONU is over threshold.

This trap indicates the memory-utilization of ONU falls under threshold.

This trap indicates that detect ONU's i2c fail.

optionModuleRemoved Trap is sent when option Module was removed.

This trap indicates that ONU's low threshold Rx Optic power Alarm is On.

This trap indicates that ONU's low threshold Rx Optic power Alarm is Off.

This trap indicates that ONU's high threshold Rx Optic power Alarm is On.

This trap indicates that ONU's high threshold Rx Optic power Alarm is Off.

Description

Description

Description

Description

Description

Description

Memory over HighThreshold trap when used memory size is over the given limit.

Description

Description

Description

Description

Description

Description

Description

Description

Description

Description

Memory fall under HighThreshold trap when used memory size fall under the given limit.

Description

Description

Description

Description

Description

Description

Description

Description

Description

Description

slotInstalledTrap Trap is sent when Board was installed.

Description

Description

slotRemovedTrap Trap is sent when Board was removed.

slotStateChangeTrap Trap is sent when Board State change.

Power status OK trap when powerStatus change from disable to enable.

CRC Load over HighThreshold trap when crcLoad is over the given limit.

CRC Load fall under HighThreshold trap when crcLoad fall under the given limit.

The temperatureHighOverThreshold Trap is sent when temperature is over the high-threshold.

The temperatureHighFallThreshold Trap is sent when temperature fall the high-threshold.

The temperatureLowOverThreshold Trap is sent when 1st temperature is over the low-threshold.

The temperatureLowFallThreshold Trap is sent when temperature fall under the low-threshold.

The user-login trap is sent when user login.

The user-logout trap is sent when user logout.

The restoreFactory trap is sent when user initialize as factory defaults.

The cpuloadHighOverThreshold Trap is sent when cpuload is over the high-threshold.

Power status fail trap when powerStatus change from enable to disable.

The cpuloadHighFallThreshold Trap is sent when cpuload fall the high-threshold.

The cpuloadLowOverThreshold Trap is sent when 1st cpuload is over the low-threshold.

The cpuloadLowFallThreshold Trap is sent when cpuload fall under the low-threshold.

System NOS Upgrade status

Fan status OK trap when fanStatus change from disable to enable.

Loss of Framing threshold reached(ATUC)

Loss of signal threshold reached(ATUC)

Loss of power threshold reached (ATUC)

Errored Seconds threshold reached (ATUC)

Changed atuc rate

Loss of Link threshold reached (ATUC)

Fan status fail trap when fanStatus change from enable to disable.

Loss of Framing threshold reached(ATUR)

Loss of signal threshold reached(ATUR)

Loss of power threshold reached (ATUR)

Errored Seconds threshold reached (ATUR)

Trap is sent with CPE Serial No., Mac Address of CPE, after CPE serial change.

Power Installed trap when power was installed.

Cfgdblocked Trap is sent when a certain port is blocked by cpu-flood-guard mechanism.

CfgdReleased Trap is sent when a certain port is non-blocked by cpu-flood-guard mechanism.

CfgdOverThreshold Trap is sent when a certain port is over the threshold by cpu-flood-guard mechanism.

CfgdUnderThreshold Trap is sent when a certain port fall under the threshold by cpu-flood-guard mechanism

Sfgdblocked Trap is sent when a certain port is blocked by system-flood-guard mechanism.

SfgdReleased Trap is sent when a certain port is non-blocked by system-flood-guard mechanism.

SfgdOverThreshold Trap is sent when a certain port is over the threshold by system-flood-guard mechanism.

SfgdUnderThreshold Trap is sent when a certain port fall under the threshold by system-flood-guard mechanism

ppsControlBlocked Trap is sent when a certain port is blocked by PPS-Control mechanism.

Power removed trap when power was removed.

ppsControlReleased Trap is sent when a certain port is non-blocked by PPS-Control mechanism.

ppsControlOverThreshold Trap is sent when a certain port is over the threshold by PPS-Control mechanism.

ppsControlUnderThreshold Trap is sent when a certain port fall under the threshold by PPS-Control mechanism

This trap indicates that the system received nos-remote-upgrade command.

This trap indicates that the NOS succeeded to upgrade NOS.

This trap indicates that the system failed to download NOS by user interrup.

This trap indicates that the system failed to download NOS, for NOS header-error.

This trap indicates that the system failed to download NOS, for NOS checksum-error.

This trap indicates that the system failed to download NOS, for flash operation.

This trap indicates that the upgrade NOS process was started.

Fan Installed trap when fan was installed.

This trap indicates that Dying-gasp for power fault.

This trap indicates that some port is blocked by attack-guard.

This trap indicates that some port is unblocked by attack-guard.

This trap indicates the fan status is fault in some period.

This trap indicates the remote oam entity is in dying-gasp.

This trap indicates the remote oam entity is restored.

This trap indicates the ARP inspection is invalided.

This trap indicates the system is switchover.

This trap indicates the board state is changed.