This group gives the BSU Multiple Subnets information. 
        
The aniBsuSubnetConfTable is used to view and configure
subnets per wireless port.
        
There can be upto 1024 <Ip Address/Subnet Mask> pairs.
For a given WSS port, there can be multiple and different 
subnets. This means that each subnet specified by an
<Ip Address masked by the Subnet Mask> has to be distinct.
Atleast one Ip Address and Subnet Mask has to be specified.
In addition to the subnet being distinct, each IP Address 
must be unique too.
        
If clustering is disabled, then Multiple Subnets on one
WSS port should not clash with Multiple Subnets on any
other WSS port.
         
Clustering and multiple subnets can exists simultaneously 
as long as they are not on the same WSS. If clustering is 
enabled but not all WSS are clustered, then those that are 
not part of the cluster can have multiple subnets. 
Eg. If WSS1 and WSS2 are clustered, but WSS3 and WSS4 are 
not, then WSS3 and WSS4 can have multiple subnets.
        
To add a new subnet to the table, first set the 
aniBsuSubnetConfAddr. Next send an SNMP set request
on aniBsuSubnetConfMask.
        
Currently, deletion and modification of entries is not supported.
        
When the BSU is in Bridge mode, this multiple subnets table is 
not valid and will not be displayed.