dot1agCfmMepIfIndex

ZXR10-CFM-MIB · zte-ng variant · .1.3.6.1.4.1.3902.3.120.1.3.1.1.2
Commands MIB view Table view

Object

column InterfaceIndexOrZero 
This object is the interface index of the interface either a
bridge port, or an aggregated IEEE 802.1 link within a bridge
port, to which the MEP is attached.
Upon a restart of the system, the system SHALL, if necessary,
change the value of this variable so that it indexes the
entry in the interface table with the same value of ifAlias
that it indexed before the system restart. If no such
entry exists, then the system SHALL set this variable to 0.

Context

MIB
ZXR10-CFM-MIB
OID
.1.3.6.1.4.1.3902.3.120.1.3.1.1.2
Type
column
Access
readonly
Status
current
Parent
dot1agCfmMepEntry

Net-SNMP examples

How SNMP and these commands work

Walk the column to discover its indexed instances, or supply every index to read one instance.

Walk the column
/usr/bin/snmpbulkwalk -v2c -c '<community>' -Pud -Ir -OQUs -m 'ZXR10-CFM-MIB' -M '/opt/observium/mibs/zte-ng:/opt/observium/mibs/rfc:/opt/observium/mibs/net-snmp' 'udp:<hostname>:161' 'ZXR10-CFM-MIB::dot1agCfmMepIfIndex'
More examples
Read one indexed instance
/usr/bin/snmpget -v2c -c '<community>' -Pud -Ir -OQUv -m 'ZXR10-CFM-MIB' -M '/opt/observium/mibs/zte-ng:/opt/observium/mibs/rfc:/opt/observium/mibs/net-snmp' 'udp:<hostname>:161' 'ZXR10-CFM-MIB::dot1agCfmMepIfIndex.<dot1agCfmMdIndex>.<dot1agCfmMaIndex>.<dot1agCfmSessionId>'
Translate to a numeric OID
/usr/bin/snmptranslate -Pud -Ir -On -m 'ZXR10-CFM-MIB' -M '/opt/observium/mibs/zte-ng:/opt/observium/mibs/rfc:/opt/observium/mibs/net-snmp' 'ZXR10-CFM-MIB::dot1agCfmMepIfIndex'

Syntax

InterfaceIndexOrZero
Source
InterfaceIndexOrZero
Base type
Integer32
Display format
d
Type Description
This textual convention is an extension of the
InterfaceIndex convention.  The latter defines a
greater than zero value used to identify an interface
or interface sub-layer in the managed system.  This
extension permits the additional value of zero.  the
value zero is object-specific and must therefore be
defined as part of the description of any object which
uses this syntax.  Examples of the usage of zero might
include situations where interface was unknown, or
when none or all interfaces need to be referenced.

Values & Constraints

Type Constraints
range: 0..2147483647