zhoneSendCode

This variable indicates what type of code is
being sent across the DS1 interface by the device.
Setting this variable causes the interface to send
the code requested.  The values mean:
SendNoCode
sending looped or normal data
              
sendLineCode
sending a request for a line loopback
              
T1 related sendCodes
------------------------------------------
sendPayloadCode
sending a request for a payload loopback
              
sendResetCode
sending a loopback termination request
              
sendQRSSPattern
sending a Quasi-Random Signal  (QRS)  test
pattern
              
send511Pattern
sending a 511 bit fixed test pattern
              
send3in24Pattern
sending a fixed test pattern of 3 bits set
in 24
              
sendOtherTestPattern
sending a test pattern  other  than  those
described by this object
              
send2047Pattern,
sending 2047 test pattern.
              
send1in2Pattern,
sending alternate one , zero pattern.
              
sendInbandCode,
sending inband loopback command.
              
sendInbandCodeOff,
sending inband loopback off command.
              
sendLineCodeOff,
sending line loopback command.
              
sendPayloadCodeOff,
sending payload loopback command.
              
E1 related send codes
------------------------------------------
send2ToPower9Minus1Pattern
refer to O.153
              
send2ToPower11Minus1Pattern
refer to O.152 and O.153
              
send2ToPower15Minus1Pattern
refer to O.151
              
send2ToPower20Minus1Pattern
refer to O.153 QRSS bit = 1
              
send2ToPower23Minus1Pattern
refer to O.151
              
Only sendNoCode is supported on E1 platforms 
in this release.
N/A for BAN

MIB

ZHONE-Wan-MIB

OID

.1.3.6.1.4.1.5504.5.2.2.1.6

Type

column

Access

readwrite

Status

current

Parent

zhoneDs1Entry