wtWebioEA2x2ERPLoadControlView

Here the result of automatic load control can be read. All output were tested in 
pairs (0-1). If an error occours at one output,
both output of an pair will be switched of. For a properly function of the load control
each output of a pair have to has a load. If there is no existing load, a pull down resistor
can be used.
Outputs with no load are automaticly detected and not part of the control function.
The OCTETS are interpreted bit-by-bit, with each bit corresponding to an output. 
Bit 0 corresponds to the LSB.
Octet 1: unused
Octet 2: unused
Octet 3: unused
Octet 4: 
	        Bit 0-1: outputs 0-1.

MIB

Webio-Digital-MIB-US

OID

.1.3.6.1.4.1.5040.1.2.25.3.1.5.4

Type

scalar

Access

readonly

Status

mandatory

Parent

wtWebioEA2x2ERPAlarm