wtWebioEA24oemLCShutDownView

Here the result of the automatic load control shut down can be read. All outputs remain switched of,
until a zero is written into this variable. But previously all loads should be inspected.
High current (short circuit), a broken supply line or a defect load (i.e. lamp) may be a shut down reason.
If no load is detected, the load control unit suspend automaticly the control of the corresponding output pair.
All controlled output could be identified reading the variable wtWebioEA24oemLoadControlEnable.
The OCTETS are interpreted bit-by-bit, with each bit corresponding to an output.
Bit 0 corresponds to the LSB.
          
Octet 1: unused
OCTET 2: Bit 0-7 : outputs 16 - 23
OCTET 3: Bit 0-7 : outputs  8 - 15
OCTET 4: Bit 0-7 : outputs  0 - 7

MIB

Webio-Digital-MIB-US

OID

.1.3.6.1.4.1.5040.1.2.14.3.1.5.5

Type

scalar

Access

readwrite

Status

mandatory

Parent

wtWebioEA24oemAlarm