wtWebio577xxEA1x1LoadControlEnable

Webio-Digital-MIB-US · .1.3.6.1.4.1.5040.1.2.48.3.1.4.3
Commands MIB view Table view

Object

scalar mandatory r/w OctetString 
Here the function of automatic load control can be enabled. All output were tested in 
pairs (0-1). If an error occours at one output,
both output of an pair will be switched of. For a properly function of the load control
each output of a pair have to has a load. If there is no existing load, a pull down resistor
can be used.
Outputs with no load are automaticly detected and not part of the control function.
The OCTETS are interpreted bit-by-bit, with each bit corresponding to an output. 
Bit 0 corresponds to the LSB.
Octet 1: unused
Octet 2: unused
Octet 3: unused
Octet 4:
	Bit 1-7: unused
        Bit 0  : Load Control enable

Context

MIB
Webio-Digital-MIB-US
OID
.1.3.6.1.4.1.5040.1.2.48.3.1.4.3
Type
scalar
Access
readwrite
Status
mandatory
Parent
wtWebio577xxEA1x1OutputMode

Net-SNMP examples

How SNMP and these commands work

Scalars have one instance, identified by the .0 suffix.

Read the scalar instance
/usr/bin/snmpget -v2c -c '<community>' -Pud -Ir -OQUv -m 'Webio-Digital-MIB-US' -M '/opt/observium/mibs/webgraph:/opt/observium/mibs/rfc:/opt/observium/mibs/net-snmp' 'udp:<hostname>:161' 'Webio-Digital-MIB-US::wtWebio577xxEA1x1LoadControlEnable.0'
More examples
Translate to a numeric OID
/usr/bin/snmptranslate -Pud -Ir -On -m 'Webio-Digital-MIB-US' -M '/opt/observium/mibs/webgraph:/opt/observium/mibs/rfc:/opt/observium/mibs/net-snmp' 'Webio-Digital-MIB-US::wtWebio577xxEA1x1LoadControlEnable'

Syntax

OctetString

Values & Constraints

No enumerated values or constraints recorded.