wlsxTrapTargetAPSSID – WLSX-TRAP-MIB

Object

scalar SNMPv2-TCDisplayString

This object is used in the traps to indicate the SSID of the
access point, for which the trap is being raised. If an
Air Monitor is sending the trap then this will indicate
AP. If an access point is sending the trap, then it will point
to itself.

Context

MIB: WLSX-TRAP-MIB
OID: .1.3.6.1.4.1.14823.2.3.1.11.1.1.6
Type: scalar
Access: notifyonly
Status: current
Parent: wlsxTrapObjectsGroup

Net-SNMP examples

How SNMP and these commands work

Scalars have one instance, identified by the .0 suffix.

Read the scalar instance

/usr/bin/snmpget -v2c -c '<community>' -Pud -Ir -OQUv -m 'WLSX-TRAP-MIB' -M '/opt/observium/mibs/aruba:/opt/observium/mibs/rfc:/opt/observium/mibs/net-snmp' 'udp:<hostname>:161' 'WLSX-TRAP-MIB::wlsxTrapTargetAPSSID.0'

More examples

Translate to a numeric OID

/usr/bin/snmptranslate -Pud -Ir -On -m 'WLSX-TRAP-MIB' -M '/opt/observium/mibs/aruba:/opt/observium/mibs/rfc:/opt/observium/mibs/net-snmp' 'WLSX-TRAP-MIB::wlsxTrapTargetAPSSID'

Syntax

SNMPv2-TCDisplayString

Source: SNMPv2-TCDisplayString
Base type: OctetString
Display format: 255a

Type Description

Represents textual information taken from the NVT ASCII
          
character set, as defined in pages 4, 10-11 of RFC 854.
          
To summarize RFC 854, the NVT ASCII repertoire specifies:
          
  - the use of character codes 0-127 (decimal)
          
  - the graphics characters (32-126) are interpreted as
    US ASCII
          
  - NUL, LF, CR, BEL, BS, HT, VT and FF have the special
    meanings specified in RFC 854
          
  - the other 25 codes have no standard interpretation
          
  - the sequence 'CR LF' means newline
          
  - the sequence 'CR NUL' means carriage-return
          
  - an 'LF' not preceded by a 'CR' means moving to the
    same column on the next line.
          
  - the sequence 'CR x' for any x other than LF or NUL is
    illegal.  (Note that this also means that a string may
    end with either 'CR LF' or 'CR NUL', but not with CR.)
          
Any object defined using this syntax may not exceed 255
characters in length.

Values & Constraints

Object Constraints

range: 0-64

Type Constraints

range: 0..255