wanAtmStatsInIncorrectMsgs

The Incorrect Messages Counter reflects any sort of incorrect
information in a message.  This includes:
              
? RELEASE, RELEASE COMPLETE, ADD PARTY REJECT, and 
  STATUS messages transmitted or received, that contain any of
  the Cause values listed below.
? Ignored messages.  These messages are dropped because the
  message was so damaged that it could not be further processed.
  A list of dropped messages is compiled below:
  Message with invalid protocol discriminator
  Message with errors in the call reference I.E.
? Bits 5-8 of the first octet not equal to '0000'
? Bits 1-4 of the first octet indicating a length other than
  3 octets
? RELEASE COMPLETE message received with a call 
  reference that does not relate to a call active or in progress
? SETUP message received with call reference flag incorrectly 
  set to 1
? SETUP message received with a call reference for a call that is 
  already active or in progress.
  Message too short
              
The following cause values are monitored by this counter
(Note: These cause values apply to both UNI3.0 and UNI3.1 unless
otherwise stated)
   Cause Value          Meaning
   10            VPCI/VCI unacceptable (UNI3.0 only)
   36            VPCI/VCI assignment failure (UNI3.1 only)
   81            invalid call reference value
   82            identified channel does not exist
   89            invalid endpoint reference
   96            mandatory information element is missing
   97            message type non-existent or not
                 implemented
   99            information element non-existent or not
                 implemented
   100           invalid information element contents
   101           message not compatible with call state
   104           incorrect message length
   111           protocol error, unspecified
              
NOTE:  For this counter, RELEASE COMPLETE messages that are a
reply to a previous RELEASE message and contain the same cause
value, are redundant (for counting purposes) and should not be
counted.

MIB

WANSTATS-MIB

OID

.1.3.6.1.4.1.11.2.3.7.6.1.5.1.8.1.1.5.1.17

Type

column

Access

readonly

Status

current

Parent

wanAtmStatsEntry