tFilterEmbedOpenflowOperStateChg

The tFilterEmbedOpenflowOperStateChg notification is generated when
the operational state of an open-flow switch embedded in a filter with
scope other than 'embedded' has changed.
          
[CAUSE] This notification may be triggered for the following reasons:
          
1) An attempt to embed an open-flow switch into an embedding filter
   was done.
2) An attempt to recover an open-flow embedding that is operationally
   down was done.
3) An attempt to change the admin state of an open-flow embedding
   was done.
4) The operational state of an open-flow embedding has changed
   to inactive due to lack of resources.
          
[EFFECT] The effect depends on the new state. If the new state is
'active', the embedding of an open-flow switch was successful.
          
If the new state is 'embedFailedNoResources' the embedding was not
successful due to lack of resources.
          
If the new state is 'inactive' and the previous state was 'active'
then the open-flow switch entries were removed. Otherwise the
embedding filter was not changed.
          
[RECOVERY] If the new state is 'active' or 'inactive', no action is
required.
          
If the new state is 'embedFailedNoResources', an attempt to recover
the operational state can be done by removal and reapplication of the
open-flow embedding.

MIB

TIMETRA-FILTER-MIB

OID

.1.3.6.1.4.1.6527.3.1.3.21.0.12

Type

notification

Status

current

Parent

tFilterNotifications

Groups

2