smfCfgOperationalMode
SMF-MIB ·
.1.3.6.1.3.126.1.2.5
Object
scalar
r/w
Integer32
The SMF RSS node operational mode and
RSSA combination active on this
local forwarder. This object is defined
to be equal to the smfCapabilitiesIndex,
which identifies the specific active
operational mode and RSSA.
The default value for this object is
'1', which corresponds to:
smfCapabilitiesOpModeID i 'cfOnly(1)'
smfCapabilitiesRssaID i 'cF(1)'
This object is persistent and, when written,
the entity SHOULD save the change to
non-volatile storage.
Context
- MIB
- SMF-MIB
- OID
.1.3.6.1.3.126.1.2.5- Type
- scalar
- Access
- readwrite
- Status
- current
- Parent
- smfConfigurationGroup
- Siblings
- 13
Syntax
Integer32
Values & Constraints
Object Constraints
range: 1-2147483647
Related Objects
Sibling Objects
| Object | Type | Syntax | OID |
|---|---|---|---|
| smfCfgAdminStatus The configured status of the SMF process
on this device. 'enabled(1)' means that
SMF is configured to run on this device.
'disabled(2)' means that the SMF process
is configured o… | scalar | SmfStatus | .1.3.6.1.3.126.1.2.1 |
| smfCfgDpdEntryMaxLifetime The maximum lifetime of a cached DPD
record in the local device storage.
If the memory is running low prior to the
MaxLifetime being exceeded, the local SMF
devices sho… | scalar | Seconds Integer32 | .1.3.6.1.3.126.1.2.10 |
| smfCfgNhdpRssaMesgTLVIncluded Indicates whether or not the associated NHDP
messages include the RSSA Message TLV. This
is an optional SMF operational setting.
The value 'true(1)' indicates that this TLV is
in… | scalar | SNMPv2-TCTruthValue | .1.3.6.1.3.126.1.2.11 |
| smfCfgNhdpRssaAddrBlockTLVIncluded Indicates whether or not the associated NHDP
messages include the RSSA Address Block TLV.
This is an optional SMF operational setting.
The value 'true(1)' indicates that this TLV … | scalar | SNMPv2-TCTruthValue | .1.3.6.1.3.126.1.2.12 |
| smfCfgAddrForwardingTable The smfCfgAddrForwardingTable is essentially a filter
table (if populated) that identifies addresses/packets
to be forwarded via the local SMF flooding process.
The IP Multicast M… | table | - | .1.3.6.1.3.126.1.2.13 |
| smfCfgInterfaceTable The SMF Interface Table describes the SMF
interfaces that are participating in the
SMF packet forwarding process. The ifIndex is
from the interfaces group defined in the
Interfac… | table | - | .1.3.6.1.3.126.1.2.14 |
| smfCfgSmfSysUpTime The time (in hundredths of a second) since the
system SMF process was last re-initialized.
The SMF process is re-initialized when the
value of the 'smfCfgAdminStatus' object
trans… | scalar | SNMPv2-SMITimeTicks | .1.3.6.1.3.126.1.2.2 |
| smfCfgRouterIDAddrType The address type of the address used for
the SMF ID of this router as specified
in the 'smfCfgRouterID' next.
Only the values ipv4(1) and ipv6(2)
are supported.
… | scalar | Enumeration | .1.3.6.1.3.126.1.2.3 |
| smfCfgRouterID The IP address used as the SMF router ID.
This can be set by the management station.
If not explicitly set, then the device
SHOULD select a routable IP address
assigned to this ro… | scalar | OctetString | .1.3.6.1.3.126.1.2.4 |
| smfCfgRssaMember The RSSA downselects a set of forwarders for
multicast forwarding. Sometimes it is useful
to force an agent to be included or excluded
from the resulting RSS. This object is a
s… | scalar | Enumeration | .1.3.6.1.3.126.1.2.6 |
| smfCfgIpv4Dpd The current method for IPv4 duplicate packet
detection.
The value 'hashBased(1)' indicates that the
router's duplicate packet detection is based
upon comparing a hash o… | scalar | Enumeration | .1.3.6.1.3.126.1.2.7 |
| smfCfgIpv6Dpd The current method for IPv6 duplicate packet
detection.
The values indicate the type of method used
for duplicate packet detection as described
the previous description… | scalar | Enumeration | .1.3.6.1.3.126.1.2.8 |
| smfCfgMaxPktLifetime The estimate of the network packet
traversal time.
This object is persistent and, when written,
the entity SHOULD save the change to
non-volatile storage. | scalar | Seconds Integer32 | .1.3.6.1.3.126.1.2.9 |