an50WrlsAdaptiveMod

Setting this attribute to AdaptiveRate(2) sets the system 
to operate in adaptive modulation mode. It is recommended 
to keep the AN-50 in this mode so that the system can 
automatically adjust the modulation level to the highest possible 
data rate based on measured RF performance. The user 
can define the minimum desired modulation level by setting the 
Main rate parameter.
If the  system  meets this data  rate, then the Signal LED on the front
panel will light continuously green. If packet errors exceed 
one out of a million, the system will automatically lower the modulation
level to maintain the link. In this case, the LED will flash green.   
If errors continue when the system reaches the lowest modulation level, 
the LED will flash red to indicate a failed RF link.  
The user can also disable the dynamic modulation mode by disabling
Adaptive Modulation. In this mode, the user is required to set the 
Burst Rate and the Modulation Reduction Level. It is recommended not 
to operate the system in manual mode, as this mode is intended primarily 
for field support.
Note the Signal LED will light solid green when the packet error rate is 
less than 1 out of a million. When  the errors exceed this limit, the LED 
will not illuminate, indicating the RF link has failed.

MIB

REDLINE-AN50-MIB

OID

.1.3.6.1.4.1.10728.2.16.2.2.4

Type

scalar

Access

readwrite

Status

mandatory

Parent

an50ConfigWireless