mdlSCmd

General object for any special command at card level.
0=NotApplicable, for cards that don't support this object.
              
For KML.10(ISDN) card of KM-2100,  the object will indicate 
Manual Call Command in Switch mode. It is applicable only when
for KML.10, prtIsdnSwitchMode=manual.
KML.10 valid values:
'1' =  noOp, will be used by agents that do not support this 
       feature or object (old KM agents)
'2' = off, Set call command mode to disconnect state. Disconnects the call.
'3' = on,  Set call command mode to connect state. Connects the call.
              
For DXC IO cards, the object will be used for IO Card Reset HW command:
'2' = off, this will be always the Get value for these cards.
'3' = on,  this is the Set command used to Reset the IO card. Upon 
      completing the operation, the value will automatically change to off(2),
      by Agent.
For Slots that are NOT IO Slots and for empty IO Slots, the Get value will
be always '0' (NotApplicable).

MIB

RAD-Dacs-MIB

OID

.1.3.6.1.4.1.164.3.3.2.1.1.1.13

Type

column

Access

readwrite

Status

current

Parent

mdlSEntry