mdlCDetailedStatus

The module current status.
              
When moduleOperStatus is down(2), but not as a result of
setting the moduleAdminStatus to down(2), this object contains
the failure reason or reasons.
              
The moduleOperStatus value can be up(1) only when all bits of
this object are cleared.
              
The following failure reasons can be indicated:
              
initializing (0)
The module initialization procedure is in progress.
For a MC the start-up time may take a few minutes and the bit
should be set during this time.
              
cardMismatch (1)
There is a type mismatch between the pre-provisioned module and
the actual installed module.
              
initFailed (2)
A SW download problem from the Main Card to an I/O card.
              
provisionFailed (3)
Provisioning failure or any other initialization problem of an I/O card.
              
selfTestFailed (4)
Power-up or periodic diagnostics has detected a H/W malfunction of the card.
              
commFailure (5)
The MC detects loss of management communication with an I/O card that 
it was previously talking to. In other words, the I/O card completed
its initialization and already established communication with the MC
and at some time later the management communication failed.
              
bpInterfaceFailure (6)
One or more of the module's backplane interfaces has detected bit errors
or loss of packets.
              
configurationMismatch(7)
Indication that a configuration mismatch was detected while 
the card has been configured 
              
noInputPower(8)
Indication that module (usually a power inlet) is plugged-in  but no power
cable is attached to it.

MIB

RAD-Dacs-MIB

OID

.1.3.6.1.4.1.164.3.3.2.1.2.1.10

Type

column

Access

readonly

Status

current

Parent

mdlCEntry