sfpOptions

The options implemented in the SFP transceiver
unknown -- Unknown
rateSelect -- RATE_SELECT is implemented. 
              If this bit is not set, no control of pin is required.
              If this bit is set, then active control if the rate
              select pin is required.
              In Both cases, compliance with mlutiple rate standards
              should be determined by the following objects 
                   sfpTransceiverComplianceCodes
                   sfpFibreChannelTransmissionSpeed
txDisable -- TX_DISABLE is impelmented and disables the serial output
txFault -- TX_FAULT is implemented.
losNormal -- loss of signal implemented
               los high indicates the received optical power is below the 
               worst case receiver sensitivity (as defined by the standard
               in use.
               los low indicates normal operation
losInverted -- loss of signal implemented
               los low indicates the received optical power is below the 
               worst case receiver sensitivity (as defined by the standard
               in use.
               los high indicates normal operation

MIB

PDN-SFP-MIB

OID

.1.3.6.1.4.1.1795.2.24.14.3.1.2.1.24

Type

column

Access

readonly

Status

current

Parent

sfpInfoEntry