interopSdpDirectionAttributeEnable

Enable/Disable SDP Direction Attribute
          
Indicates if the SDP direction attribute is supported by the
unit.
          
This parameter is used only when the negotiated media uses an
IPv4 address. The application always behaves as if this
parameter is set to 'Enable' for media using an IPv6 address.
          
When disabled, the application uses the RFC 2543 method to put
a session on hold:
          
  * No direction attribute is present in the SDP sent by the
    unit.
  * Any direction attribute found in the SDP received from the
    peer is ignored by the unit.
          
When enabled, the application uses the RFC 3264 method to put
a session on hold:
          
  * The unit always sends the direction attribute in the SDP
    of an initiated call. For all other SDP messages sent by
    the unit, refer to the
    InteropSdpDetectPeerDirectionAttributeSupportEnable
    parameter.
  * If present in the SDP, the direction attribute is
    preferred over the connection address to transmit session
    modification information.

MIB

MX-SIPEP-MIB

OID

.0.1400.1.50000.900

Type

scalar

Access

readwrite

Status

current

Parent

interopGroup