softwareCuRepSwNotDistributed

LUM-SOFTWARE-MIB · .1.3.6.1.4.1.8708.2.28.2.8.7
Commands MIB view Table view

Object

scalar LUM-TCFaultStatus 
Some SW package(s) needed to perform a CU replacement with
automatic upgrade are not transferred to a traffic unit. This
means that CU replacement with auto-upgrade will not work on
this node.
          
Note that this alarm might be seen in up to approximately 5
minutes after a 'SW not downloaded' alarm is cleared to inform
that SW packages are not yet distributed.
          
Possible reasons:
1. If parts of the master CU software were updated without an
  enm-spec file there might be a mismatch between executing
  and expected software resulting in this alarm. If so
  perform a full upgrade to preferred enm-spec version.
2. More than one traffic unit might be needed to distribute
  software, insert another traffic unit into the node main
  subrack or if running CU-SFP as master CU, reconfigure the
  'Supported replacement CUs' attribute to the control unit
  type(s) appropriate for your system.

Context

MIB
LUM-SOFTWARE-MIB
OID
.1.3.6.1.4.1.8708.2.28.2.8.7
Type
scalar
Access
readonly
Status
current
Parent
softwareCuRep
Groups
1

Net-SNMP examples

How SNMP and these commands work

Scalars have one instance, identified by the .0 suffix.

Read the scalar instance
/usr/bin/snmpget -v2c -c '<community>' -Pud -Ir -OQUv -m 'LUM-SOFTWARE-MIB' -M '/opt/observium/mibs/infinera:/opt/observium/mibs/rfc:/opt/observium/mibs/net-snmp' 'udp:<hostname>:161' 'LUM-SOFTWARE-MIB::softwareCuRepSwNotDistributed.0'
More examples
Translate to a numeric OID
/usr/bin/snmptranslate -Pud -Ir -On -m 'LUM-SOFTWARE-MIB' -M '/opt/observium/mibs/infinera:/opt/observium/mibs/rfc:/opt/observium/mibs/net-snmp' 'LUM-SOFTWARE-MIB::softwareCuRepSwNotDistributed'

Syntax

LUM-TCFaultStatus
Source
LUM-TCFaultStatus
Base type
Enumeration
Type Description
A value indicating the current state
of a potential fault condition leading to
an alarm for an object.
          
ok - indicates that no fault condition is present
and no alarm is active or the alarm has been cleared.
          
alarm - indicates that a fault condition is present
and an alarm is active.
          
Note: The list of FaultStatus objects forms the list of all
potential alarms for the system.

Values & Constraints

Type Values
1ok
2alarm

Conformance

Member of
softwareCuRepGroupV2