hwDocsQamNGODEdgeDeviceHoldTime

This attribute identifies the number of seconds that the edge device proposes
for the value of the Hold Timer. Upon receipt of an OPEN message, a VREP speaker or
listener MUST calculate the value of the Hold Timer by using the smaller of its
configured Hold Time and the Hold Time received in the OPEN message. The Hold
Time MUST be either zero or at least three seconds. The calculated value indicates the maximum
number of seconds that may elapse between the receipt of successive KEEPALIVE and/or UPDATE messages by the sender.
If the Hold Timer is zero, then no procedures are necessary for keeping a peering session alive.
The default value is 240. 
Unit: s.

MIB

HUAWEI-EQAM-AN-MIB

OID

.1.3.6.1.4.1.2011.6.187.11.1.10

Type

column

Access

readwrite

Status

current

Parent

hwDocsQamNGODEdgeDeviceEntry