job-input-auto-continue-timeout

The number of seconds the device waits after a job
related continuable error occurs before automatically
continuing.  An example job related continuable error is
the job requesting a media size that is not available.
After the timeout expires, the device will continue
processing the job as if a continue event occurred, such
as the front panel continue key being pressed.  If the
value is -1, the device does not automatically continue
after a job related continuable error occurs.  If the
value is 0, the device immediately continues.  If the
value is greater than 0, the value represents the
timeout value in seconds.
Additional information:
This object is used only for media requests
		           (size and/or name).   LaserJet 4050 Series supports any value in 
			   the range of -1 to 3600. Setting to a value outside 
			   of that range causes the printer to substitute a 
			   value (listed below) and to return 
			   <noError> status.   The 
			   values are as follow:   <-1 snaps to -1  
			   >3600 snaps to 3600  (60 minutes)   The action that 
			   occurs when this timeout expires is explained by
			   JOB-INPUT-AUTO-CONTINUE-MODE. It is not the same as 
			   the CONTINUE object being set to eInitiateAction or 
			   the Select key being pressed on the control panel. 
			   See the CONTINUE object description for 
			   information on the actions that occur for those 
			   conditions. 
	                   The data for this object is stored in NVRAM.

MIB

HP-LASERJET-COMMON-MIB

OID

.1.3.6.1.4.1.11.2.3.9.4.2.1.1.2.35

Type

scalar

Access

readwrite

Status

mandatory

Parent

status-system