fax-country
HP-LASERJET-COMMON-MIB ·
.1.3.6.1.4.1.11.2.3.9.4.2.1.3.7.1.9
Object
scalar
mandatory
r/w
Enumeration
Note: Non-backwards compatible change make in version
4.7. Returns which country the telephone-electronics
(LIU) is configured for.
If this object is implemented with an access of read-write
the device POS will specify what occurs when this object
is written.
Additional information:
GECKO NOTE: Is enumeration 37 (eSwitzerlandFrench)
the correct setting for Switzerland? The mib also
provides the following options:
eSwitzerland(36)
eSwitzerlandGerman(36)
eSwitzerlandItalian(38)
Context
- MIB
- HP-LASERJET-COMMON-MIB
- OID
.1.3.6.1.4.1.11.2.3.9.4.2.1.3.7.1.9- Type
- scalar
- Access
- readwrite
- Status
- mandatory
- Parent
- settings-fax-proc-sub
- Siblings
- 26
Syntax
Enumeration
Values & Constraints
No enumerated values or constraints recorded.
Related Objects
Sibling Objects
| Object | Type | Syntax | OID |
|---|---|---|---|
| fax-rxscale mandatory Received faxes are to be printed at a reduced scale
percentage. Value of 0 indicates auto-scaled printing
based on the length of the received fax image and the
length of the pape… | scalar | Integer32 | .1.3.6.1.4.1.11.2.3.9.4.2.1.3.7.1.1 |
| fax-tx-phone-number mandatory Phone number about to be dialed. | scalar | SNMPv2-TCDisplayString | .1.3.6.1.4.1.11.2.3.9.4.2.1.3.7.1.10 |
| fax-redial-time mandatory Number of seconds one must wait between the current
redial (set by FAX-WHICH-REDIAL) and any prior dialing. | scalar | Integer32 | .1.3.6.1.4.1.11.2.3.9.4.2.1.3.7.1.14 |
| fax-pstn-access-code mandatory The code used within a PBX to get access to an outside
PSTN line. Typically this is ''9''. | scalar | SNMPv2-TCDisplayString | .1.3.6.1.4.1.11.2.3.9.4.2.1.3.7.1.18 |
| fax-rx-disposition mandatory Indicates what is to be done with the incoming fax
call.
ePrintOnly - New fax arrivals only go to the printer.
If printer becomes unavailable, the fax is stored in
device memo… | scalar | Enumeration | .1.3.6.1.4.1.11.2.3.9.4.2.1.3.7.1.19 |
| fax-error-correction-mode mandatory Indicates whether the device is configured to send
and receive faxes in error correction mode (ECM).
This object controls both receiving and transmitting
in ECM. A value of eDisab… | scalar | Enumeration | .1.3.6.1.4.1.11.2.3.9.4.2.1.3.7.1.21 |
| fax-report-transmission mandatory Provides a host application with the ability to
print a fax transmission report. The supported
enumerations are:
eNone - no transmission report printed
ePrintReport - trans… | scalar | Enumeration | .1.3.6.1.4.1.11.2.3.9.4.2.1.3.7.1.22 |
| fax-report-activity-log mandatory Specifies when a report of fax transactions is to be
printed.
eNever - to never print a transaction report.
eThreshold - to automatically print a transaction
re… | scalar | Enumeration | .1.3.6.1.4.1.11.2.3.9.4.2.1.3.7.1.23 |
| fax-dial-tone-detection mandatory Determines whether the fax machine waits for a dial tone
before dialing a fax number. eEnabled - causes the fax
machine to wait until a dial tone is recognized before
attempting t… | scalar | Enumeration | .1.3.6.1.4.1.11.2.3.9.4.2.1.3.7.1.24 |
| fax-alarm-volume mandatory Range is 0..100, where 0 = quietest possible, and
100 = loudest possible. A device shall divide this value
into ranges corresponding to the possible volumes and
document these set… | scalar | Integer32 | .1.3.6.1.4.1.11.2.3.9.4.2.1.3.7.1.25 |
| fax-beep-volume mandatory Range is 0..100, where 0 = quietest possible, and
100 = loudest possible. A device shall divide this value
into ranges corresponding to the possible volumes and
document these set… | scalar | Integer32 | .1.3.6.1.4.1.11.2.3.9.4.2.1.3.7.1.26 |
| fax-ring-volume mandatory Range is 0..100, where 0 = quietest possible, and
100 = loudest possible. A device shall divide this value
into ranges corresponding to the possible volumes and
document these set… | scalar | Integer32 | .1.3.6.1.4.1.11.2.3.9.4.2.1.3.7.1.27 |
| fax-master-host mandatory Identifies the hostname of the master host to which
the device is connected. | scalar | SNMPv2-TCDisplayString | .1.3.6.1.4.1.11.2.3.9.4.2.1.3.7.1.28 |
| fax-thumbnail-enable mandatory Controls whether or not a thumbnail reprint of the
first page of a fax shall be included on the
fax call report. When set to eEnabled a thumbnail shall
be included on the report.… | scalar | Enumeration | .1.3.6.1.4.1.11.2.3.9.4.2.1.3.7.1.29 |
| fax-noise-volume mandatory Range is 0..100, where 0 = quietest possible, and 100 =
loudest possible. A device shall divide this value into
ranges corresponding to the possible volumes.
Additional informati… | scalar | Integer32 | .1.3.6.1.4.1.11.2.3.9.4.2.1.3.7.1.3 |
| fax-phone-pickup-enable mandatory This object is included to handle the situation where a
fax machine and a telephone share the same phone line.
If a call picked up at the phone turns out to be a f… | scalar | Enumeration | .1.3.6.1.4.1.11.2.3.9.4.2.1.3.7.1.30 |
| fax-adf-scan-count mandatory This object tracks the page count for the pages scanned for
faxing from the ADF. In order to write this object
SERVICE-PASSWORD must be set correctly.
Additional information:
This… | scalar | Integer32 | .1.3.6.1.4.1.11.2.3.9.4.2.1.3.7.1.31 |
| fax-print-page-count mandatory This object tracks the page count for the pages sent to the
print engine for fax jobs. In order to write this object
SERVICE-PASSWORD must be set correctly.
Additional information… | scalar | Integer32 | .1.3.6.1.4.1.11.2.3.9.4.2.1.3.7.1.32 |
| fax-download-page-count mandatory This object tracks the page count for the pages downloaded to
the peripheral for fax jobs. In order to write this object
SERVICE-PASSWORD must be set correctly.
Additional informa… | scalar | Integer32 | .1.3.6.1.4.1.11.2.3.9.4.2.1.3.7.1.33 |
| fax-upload-page-count mandatory This object tracks the page count for the pages uploaded from
the peripheral for fax jobs. In order to write this object
SERVICE-PASSWORD must be set correctly.
Additional informa… | scalar | Integer32 | .1.3.6.1.4.1.11.2.3.9.4.2.1.3.7.1.34 |
| fax-flatbed-scan-count mandatory This object tracks the page count for the pages scanned for
faxing from the flatbed. In order to write this object the
SERVICE-PASSWORD must be set.
Additional information:
This o… | scalar | Integer32 | .1.3.6.1.4.1.11.2.3.9.4.2.1.3.7.1.36 |
| default-fax-glass-size mandatory Indicates the default fax glass size.
Additional information:
Indicates the default fax glass size. | scalar | Enumeration | .1.3.6.1.4.1.11.2.3.9.4.2.1.3.7.1.37 |
| fax-cold-reset-fax-glass-size mandatory Returns or sets the fax glass size that is used as the
DEFAULT-FAX-GLASS-SIZE when a cold reset occurs.
Additional information:
Returns or sets the fax glass size that is used as … | scalar | Enumeration | .1.3.6.1.4.1.11.2.3.9.4.2.1.3.7.1.38 |
| fax-download mandatory Note: Changed enumeration values in a non-backwards
manner in version 4.7. Handshake mechanism between host
and device to initiate and coordinate the download of
fax image data … | scalar | Enumeration | .1.3.6.1.4.1.11.2.3.9.4.2.1.3.7.1.6 |
| fax-silent-detection mandatory When enabled, this object causes the FAX machine to
assume that the caller is a FAX even though the line has
remained silent for a time (i.e., no CNG detected).
When disabled, a C… | scalar | Enumeration | .1.3.6.1.4.1.11.2.3.9.4.2.1.3.7.1.7 |
| fax-ring-enable mandatory When the phone line rings, this object determines
whether an audible ring shall be emitted. | scalar | Enumeration | .1.3.6.1.4.1.11.2.3.9.4.2.1.3.7.1.8 |