fsMplsPsSwitchCondition

The following switch initiation criteria exist:
1. an externally initiated command(clear, lockout of protection, 
   forced switch, manual switch);
2. an automatically initiated command(signal fail) associated with
   a protection domain; or
3. a state (wait to restore, no request) of the protection switching
   function.
The followings are switch request priority:
1. clear: This command clears all of the externally initiated switch commands
   listed below.
2. lockout of protection(LoP): Fix the selector position on the working LSP.
   Prevents the selector from switching to the protection LSP when it is
   selecting the working LSP. Switches the selector from the protection to
   the working LSP when it is selecting the protection LSP.
3. forced switch(FS) for working LSP: Switches the selector from the working
   LSP to the protection LSP (unless a higher priority switch request(i.e., LoP)
   is in effect).
4. signal fail: Signal fail(SF) is declared when the source of the protection
   domain enters the LSP defect state by receiving a BDI packet from the return
   LSP or out of band.
5. manual switch(MS): Switches the selector from the working LSP to the
   protection LSP (unless an equal or higher priority switch request
   (i.e., LoP, FS, SF or MS) is in effect). Switches the selector from
   the protection LSP to the working LSP (unless an equal or higher
   priority switch request(i.e., LoP, FS, SF or MS) is in effect).
6. WTR: Wait to restore is only applicable for the revertive mode and applies
   to a working LSP.
7. no request.

MIB

FS-MPLSOAM-MIB

OID

.1.3.6.1.4.1.52642.1.1.10.2.93.1.3.1.1.11

Type

column

Access

readonly

Status

current

Parent

fsMplsPsEntry