efdmimDeviceSwitchSettings

This describes the dip and jumper settings 
physically set on the efdmim board.      
          
   Switch               multiply 2**n
     Root                      0
     Forward Broadcasts        1
     Spanning Tree             2
     BPDU Type                 3
     Bypass                    4
     Ring Select               5
     Diagnostics               6
     Mode                      7
                
Root:               If 0, then spanning tree root is 
                  selected.  If 1, then spanning 
                  tree root is NOT selected.
Forward Broadcasts: If 0, then all broadcast packets 
                  are forwarded.  If 1, then all 
                  broadcasts packets are filtered.
Spanning Tree:      If 0, then spanning tree 
                  facilities are enabled. If 1, 
                  then spanning tree facilities 
                  are disabled.
BPDU Type:          If 0, then spanning tree uses 
                  the IEE bridge packet protocol. 
                  If 1, then spanning tree uses 
                  the DEC bridge packet protocol. 
Bypass:             If 0, then there is an optical 
                  bypass physically attached to 
                  the bridge.  If 1, then there is 
                  not an optical bypass attached 
                  to the bridge.
Ring Select:        If 0, the bridge should attach 
                  to the primary FDDI ring 
                  (Through-A mode).  If 1, the 
                  bridge should attach to the 
                  secondary FDDI ring (Through-B 
                  mode). 
Diagnostics:        If 0, the bridge is in it's 
                  normal mode of operation. If 1, 
                  then the bridge is running self 
                  diagnostics. 
Mode:               If 0, the bridge is an 
                  encapsulating bridge (talks from 
                  ethernet to ethernet using FDDI 
                  only as a backbone). If 1, the 
                  bridge is a translation bridge ( 
                  talks ethernet to ethernet, and 
                  ethernet to FDDI).

MIB

EFDMIM-MIB

OID

.1.3.6.1.4.1.52.1.6.4.1.28

Type

scalar

Access

readonly

Status

mandatory

Parent

rev1