dslRateXturMaxInterleaveDelay
E5-120-MIB ·
.1.3.6.1.4.1.6321.1.2.3.3.8.16.1.1.6
Object
column
r/w
milli-seconds Integer32
Configured maximum Interleave Delay for this channel.
Interleave delay applies only to the interleave channel
and defines the mapping (relative spacing) between
subsequent input bytes at the interleaver input and
their placement in the bit stream at the interleaver
output. Larger numbers provide greater separation
between consecutive input bytes in the output bit
stream allowing for improved impulse noise immunity
at the expense of payload latency
Context
- MIB
- E5-120-MIB
- OID
.1.3.6.1.4.1.6321.1.2.3.3.8.16.1.1.6- Type
- column
- Access
- readwrite
- Status
- current
- Units
- milli-seconds
- Parent
- dslRateEntry
- Table
- dslRateTable
- Siblings
- 7
Syntax
milli-seconds Integer32
Values & Constraints
Object Constraints
range: 0-255
Related Objects
Sibling Objects
| Object | Type | Syntax | OID |
|---|---|---|---|
| dslRateMode Configure DSL Rate configuration mode of the specified ports.
Profile: the DSL Rate configuration comes from DSL profile.
Line: the DSL Rate configuration comes from line configur… | column | Enumeration | .1.3.6.1.4.1.6321.1.2.3.3.8.16.1.1.1 |
| dslRateLatencyMode The latency mode is fast or interleave | column | Enumeration | .1.3.6.1.4.1.6321.1.2.3.3.8.16.1.1.2 |
| dslRateXtucMaxInterleaveDelay Configured maximum Interleave Delay for this channel.
Interleave delay applies only to the interleave channel
and defines the mapping (relative spacing) between
sub… | column | milli-seconds Integer32 | .1.3.6.1.4.1.6321.1.2.3.3.8.16.1.1.3 |
| dslRateXtucMaxTxRate Configured Maximum Transmit rate for `Fast' or `Interleave' channels,
in bps. | column | kbps SNMPv2-SMIUnsigned32 | .1.3.6.1.4.1.6321.1.2.3.3.8.16.1.1.4 |
| dslRateXtucMinTxRate Configured Minimum Transmit rate for `Fast' or `Interleave' channels,
in bps | column | kbps SNMPv2-SMIUnsigned32 | .1.3.6.1.4.1.6321.1.2.3.3.8.16.1.1.5 |
| dslRateXturMaxTxRate Configured Target Signal/Noise Margin.
This is the Noise Margin the modem must achieve
with a BER of 10-7 or better to successfully complete
initialization. | column | kbps SNMPv2-SMIUnsigned32 | .1.3.6.1.4.1.6321.1.2.3.3.8.16.1.1.7 |
| dslRateXturMinTxRate Configured Maximum Transmit rate for `Fast' or `Interleave' channels,
in bps. | column | kbps SNMPv2-SMIUnsigned32 | .1.3.6.1.4.1.6321.1.2.3.3.8.16.1.1.8 |