ospfPmMultiAreaIfRemoteAddr

The IP address to which packets for this multi-area
interface should be sent.
              
On point-to-point interfaces there is no need to configure
the remote address to send packets to since packets are
sent to the AllSPFRouters address.  In this case this
field should be set to 0.0.0.0.  If this field is set to a
non-zero value on a point-to-point interface then the
multi-area interface will not go operationally up to
prevent mis-configuration.
              
For all other underlying interface types this should be
set to the address the neighbor is using as its IP Source
Address.  In this case if this field is is set to 0.0.0.0
the multi-area interface will not go operationally up as
DC-OSPF will not know where to send packets to.

MIB

DC-OSPF-MIB

OID

.1.3.6.1.4.1.629.10.3.1.28.1.5

Type

column

Access

noaccess

Status

current

Parent

ospfPmMultiAreaIfEntry