smCfgCtrlOnResetEnableDisable

Switch module configuration control on resets (default and unsolicited).
When set to enabled, the factory default IP configuration will become
active when the I/O module is reset to factory defaults by either the
management module or the I/O module. If an I/O module reset is initiated
by a source other than the management module then the previous IP configuration
will be in affect. In both these cases the MM will lose IP communications with
the IOM.
This MIB object can not be set, if MM grants switch module the Protected Mode
permission and switch module goes into Protected Mode.
              
 NOTE: The numeric values for the enumerations for enabled and disabled are non-traditional
       (i.e. - 0 and 1 are swapped), however, they cannot be changed since this MIB is already
       published.
              
NOTE: This MIB object is not applicable to modules that are running in Network Address
       Translation (NAT) Mode. A value of disabled(1) will be returned.

MIB

CME-MIB

OID

.1.3.6.1.4.1.2.3.51.2.22.3.1.1.1.9

Type

column

Access

readwrite

Status

mandatory

Parent

smControlEntry