cseFlowMcastQueryTable
CISCO-SWITCH-ENGINE-MIB ·
.1.3.6.1.4.1.9.9.97.1.2.12
Object
table
A control table used to query the switching engine by
specifying retrieval criteria for IP multicast L3 flows.
Each row instance in the table represents a query with
its parameters. The resulting data for each instance of
a query in this table is returned in the
cseFlowMcastResultTable.
The maximum number of entries (rows) in this table cannot
exceed the value of cseFlowMcastMaxQueries object.
Unlike unicast switched layer 3 flows, an IP multicast
switched flow is created and installed by software, and
is uniquely identified by flow's source IP address, and
multicast group IP address. It is stored with input Vlan
ID in the cache entry, so that the packets in the flow
will not be replicated and forwarded to the receivers on the
same (input) Vlan.
Another difference is that all IP multicast hardware
switched flows belonging to the same (source, group) are
stored only on one switch engine on a Cisco L3 switch with
distributed switch engines, whereas unicast flows identified
by certain criterion may resident on multiple switch engines
in the system.
Context
- MIB
- CISCO-SWITCH-ENGINE-MIB
- OID
.1.3.6.1.4.1.9.9.97.1.2.12- Type
- table
- Status
- current
- Parent
- cseFlow
- Siblings
- 25
- Children
- 1
Syntax
No syntax metadata recorded.
Values & Constraints
No enumerated values or constraints recorded.
Related Objects
Sibling Objects
| Object | Type | Syntax | OID |
|---|---|---|---|
| cseFlowEstablishedAgingTime The adminstrative aging time for IP established flows.
The default value for this object is implementation specific.
If the cseFlowEstablishedAgingTime is not configured to the
ap… | scalar | seconds Integer32 | .1.3.6.1.4.1.9.9.97.1.2.1 |
| cseFlowSwitchControlTable A table used to control the L3 flow switching operation, per
protocol type. | table | - | .1.3.6.1.4.1.9.9.97.1.2.10 |
| cseFlowMcastMaxQueries Maximum number of query entries allowed to be outstanding
at any time, in the cseFlowMcastQueryTable. The typical value
for this object is 5. | scalar | SNMPv2-SMIUnsigned32 | .1.3.6.1.4.1.9.9.97.1.2.11 |
| cseFlowMcastResultTable A table containing current IP multicast flow information
corresponding to all the completed queries set up in
the cseFlowMcastQueryTable, that were initiated on the switch
engine(… | table | - | .1.3.6.1.4.1.9.9.97.1.2.13 |
| cseFlowMcastSwitchStatus The current status of the global IP multicast flow switching
capability. When enabled, the switch engine will be able to
install multicast flow entries in its L3 forwarding table… | scalar | ControlStatus | .1.3.6.1.4.1.9.9.97.1.2.14 |
| cseFlowIPXEstablishedAgingTime The administrative aging time for established IPX flows. The
default value for this object is implementation specific.
The corresponding operational object is
cseFlowOperIPXAgingT… | scalar | seconds Integer32 | .1.3.6.1.4.1.9.9.97.1.2.15 |
| cseStaticIpxExtRouterTable A table of external routers which are enabled for
Layer 3 IPX switching by the switching engine.
This table may contain routers
that have not yet been discovered by the device. | table | - | .1.3.6.1.4.1.9.9.97.1.2.16 |
| cseFlowOperEstablishedAgingTime The operational aging time for IP established flows. | scalar | seconds Integer32 | .1.3.6.1.4.1.9.9.97.1.2.17 |
| cseFlowOperFastAgingTime The operational fast aging time for the established flow
entries, that have less number of packets than the value set
in the cseFlowOperFastAgePktThreshold,switched within this
t… | scalar | seconds SNMPv2-SMIUnsigned32 | .1.3.6.1.4.1.9.9.97.1.2.18 |
| cseFlowOperFastAgePktThreshold The operational packet threshold for the
cseFlowOperFastAgingTime. | scalar | packets SNMPv2-SMIUnsigned32 | .1.3.6.1.4.1.9.9.97.1.2.19 |
| cseFlowFastAgingTime The administrative fast aging time for the established flow
entries, that have less number of packets than the value set in
the cseFlowFastAgePktThreshold, switched within this t… | scalar | seconds SNMPv2-SMIUnsigned32 | .1.3.6.1.4.1.9.9.97.1.2.2 |
| cseFlowOperIPXAgingTime The operational aging time for established IPX flows. | scalar | seconds Integer32 | .1.3.6.1.4.1.9.9.97.1.2.20 |
| cseBridgedFlowStatsCtrlTable A table controls the reporting of intra-vlan statistics
for bridged flow per vlan. When a vlan is created in
a device supporting this table, a corresponding entry
of this table wi… | table | - | .1.3.6.1.4.1.9.9.97.1.2.21 |
| cseFlowIPFlowMask Indicates the flow mask for IP flows.
If dstOnly(1) is used, it enables flows based on Layer 3
destination addresses only.
If srcDst(2) is used, it enables f… | scalar | Enumeration | .1.3.6.1.4.1.9.9.97.1.2.22 |
| cseFlowIPXFlowMask Indicates the flow mask for IPX flows.
If dstOnly(1) is used, it enables flows based on Layer 3
destination addresses only.
If srcDst(2) is used, it enables … | scalar | Enumeration | .1.3.6.1.4.1.9.9.97.1.2.23 |
| cseFlowLongAgingTime The administrative long aging time for the established
flow entries. Setting to value of 0 turns off long aging. | scalar | seconds SNMPv2-SMIUnsigned32 | .1.3.6.1.4.1.9.9.97.1.2.24 |
| cseFlowExcludeTable A table controls the flow creation based on protocol
and port number. If a packet matches the protocol and
port number specified in this table entries, a flow
entry will not be es… | table | - | .1.3.6.1.4.1.9.9.97.1.2.25 |
| cseFlowStatsTable A table containing flow statistics information on each switching
engine. | table | - | .1.3.6.1.4.1.9.9.97.1.2.26 |
| cseFlowFastAgePktThreshold The administrative packet threshold setting for the
cseFlowFastAgingTime. The default for Fast Aging Packet
Threshold is 0, i.e. no packets switched within the time
set in cseFlow… | scalar | packets SNMPv2-SMIUnsigned32 | .1.3.6.1.4.1.9.9.97.1.2.3 |
| cseRouterTable A table containing information about all routers that are
discovered by the switch, including internal and external
routers. | table | - | .1.3.6.1.4.1.9.9.97.1.2.4 |
| cseStaticExtRouterTable A table of external routers which are enabled for Layer 3 IP
switching by the switching engine. This table may contain
routers that have not yet been discovered by the device. | table | - | .1.3.6.1.4.1.9.9.97.1.2.5 |
| cseRouterVlanTable The table listing the MAC address used by routers on
particular VLANs. | table | - | .1.3.6.1.4.1.9.9.97.1.2.6 |
| cseFlowMaxQueries Maximum number of query entries allowed to be outstanding at
any time, in the cseFlowQueryTable. The typical value for
this object is 5. | scalar | SNMPv2-SMIUnsigned32 | .1.3.6.1.4.1.9.9.97.1.2.7 |
| cseFlowQueryTable A control table used to query the switching engine by
specifying retrieval criteria for L3 flows.
The resulting data for each instance of a query in this
table is returned in the … | table | - | .1.3.6.1.4.1.9.9.97.1.2.8 |
| cseFlowDataTable A table containing L3 flow information corresponding to all
the completed queries setup in the cseFlowQueryTable, that were
initiated on the switch engine(s). | table | - | .1.3.6.1.4.1.9.9.97.1.2.9 |
Child Objects
| Object | Type | Syntax | OID |
|---|---|---|---|
| cseFlowMcastQueryEntry A conceptual row of the cesMcastFlowQueryTable used to
setup retrieval criteria to search for IP multicast L3
flows on all switching engine entities in the device.
The actual sear… | row | - | .1.3.6.1.4.1.9.9.97.1.2.12.1 |