clMeshLtDataRate
CISCO-LWAPP-MESH-LINKTEST-MIB ·
.1.3.6.1.4.1.9.9.606.1.2.1.1.4
Object
This object represents the data rate on backhaul link at which link test will be performed. Depending on the backhaul radio type, data rate will vary. if the backhaul radio is 802.11a, data rates can be one of the following possible values. Rates - 6,9,11,12,18,24,36,48,54,108 Mbps. If backhaul link is 802.11b then data rate can be 1,2,5.5,6,9,11 If backhaul link is 802.11g 1,2,5.5,6,9,11,12,18,24,36,48,54,108. This object must be set to a valid value when setting clMeshLtRowStatus to 'createAndGo' to initiate a run of linktest. This object is deprecated and superceded by clMeshLtDataRateValue object.
Context
- MIB
- CISCO-LWAPP-MESH-LINKTEST-MIB
- OID
.1.3.6.1.4.1.9.9.606.1.2.1.1.4- Type
- column
- Access
- readwrite
- Status
- deprecated
- Units
- Mbps
- Parent
- clMeshLtEntry
- Table
- clMeshLtTable
- Siblings
- 8
Syntax
Mbps SNMPv2-SMIUnsigned32
- Source
- SNMPv2-SMIUnsigned32
- Base type
Unsigned32
Values & Constraints
Type Constraints
range: 0..4294967295
Related Objects
Sibling Objects
| Object | Type | Syntax | OID |
|---|---|---|---|
| clMeshLtIndex This object uniquely identifies one particular
run of the linktest initiated between the two mesh
node neighbors identified by clMeshLtSrcMacAddress
and clMeshLtDestMacAddress. | column | Unsigned32 | .1.3.6.1.4.1.9.9.606.1.2.1.1.1 |
| clMeshLtSrcMacAddress This object represents the source mac address of AP
which initiates the link test to
'clMeshLtDestMacAddress' involved in the particular run
of linktest. This object must be set… | column | SNMPv2-TCMacAddress | .1.3.6.1.4.1.9.9.606.1.2.1.1.2 |
| clMeshLtDestMacAddress This object represents the destination mac address of
AP involved in the particular run of linktest. This
object must be set to a valid value when setting
clMeshLtRowStatus to 'cr… | column | SNMPv2-TCMacAddress | .1.3.6.1.4.1.9.9.606.1.2.1.1.3 |
| clMeshLtPktsPerSec This object represents the number of packets to be
sent per sec during link test. | column | packets Unsigned32 | .1.3.6.1.4.1.9.9.606.1.2.1.1.5 |
| clMeshLtPktSize This object represents the size of packets to be sent
during link test. | column | bytes Unsigned32 | .1.3.6.1.4.1.9.9.606.1.2.1.1.6 |
| clMeshLtDuration This object represents the duration, in seconds, of link
test to be performed. | column | seconds Unsigned32 | .1.3.6.1.4.1.9.9.606.1.2.1.1.7 |
| clMeshLtRowStatus This object is the status column used for creating
and deleting instances of the columnar objects in
this table. | column | SNMPv2-TCRowStatus | .1.3.6.1.4.1.9.9.606.1.2.1.1.8 |
| clMeshLtDataRateValue This object represents the data rate on backhaul link
at which link test will be performed. Depending on the
backhaul radio type, data rate will vary.
If the valu… | column | Enumeration | .1.3.6.1.4.1.9.9.606.1.2.1.1.9 |