currSoftSaveToFile – AT-SETUP-MIB – Observium MIB Browser

Object

scalar r/w SNMPv2-TCDisplayString

Set with a URL (e.g. 'flash:/filename.rel' or
'card:/filename.rel') to save the currently running software to
the root of flash or SD card. Only one save operation can be
executed at a time across all SNMP users, and an operation may
not be started unless the current value of currSoftSaveStatus
is 'idle'. The URL must not contain whitespace characters.
          
Immediately upon executing the set action, the actual firmware
save operation will be started and continue on the device until
it has completed or a failure occurs. The current status of the
operation can be determined by reading currSoftSaveStatus, and
the result of the last completed operation is indicated by
currSoftLastSaveResult.
          
When read, this object will return the URL of the last
firmware save operation that was attempted.

Context

MIB: AT-SETUP-MIB
OID: .1.3.6.1.4.1.207.8.4.4.4.500.2.1.4
Type: scalar
Access: readwrite
Status: current
Parent: currentFirmware

Net-SNMP examples

How SNMP and these commands work

Scalars have one instance, identified by the .0 suffix.

Read the scalar instance

/usr/bin/snmpget -v2c -c '<community>' -Pud -Ir -OQUv -m 'AT-SETUP-MIB' -M '/opt/observium/mibs/allied:/opt/observium/mibs/rfc:/opt/observium/mibs/net-snmp' 'udp:<hostname>:161' 'AT-SETUP-MIB::currSoftSaveToFile.0'

More examples

Translate to a numeric OID

/usr/bin/snmptranslate -Pud -Ir -On -m 'AT-SETUP-MIB' -M '/opt/observium/mibs/allied:/opt/observium/mibs/rfc:/opt/observium/mibs/net-snmp' 'AT-SETUP-MIB::currSoftSaveToFile'

Syntax

SNMPv2-TCDisplayString

Source: SNMPv2-TCDisplayString
Base type: OctetString
Display format: 255a

Type Description

Represents textual information taken from the NVT ASCII
          
character set, as defined in pages 4, 10-11 of RFC 854.
          
To summarize RFC 854, the NVT ASCII repertoire specifies:
          
  - the use of character codes 0-127 (decimal)
          
  - the graphics characters (32-126) are interpreted as
    US ASCII
          
  - NUL, LF, CR, BEL, BS, HT, VT and FF have the special
    meanings specified in RFC 854
          
  - the other 25 codes have no standard interpretation
          
  - the sequence 'CR LF' means newline
          
  - the sequence 'CR NUL' means carriage-return
          
  - an 'LF' not preceded by a 'CR' means moving to the
    same column on the next line.
          
  - the sequence 'CR x' for any x other than LF or NUL is
    illegal.  (Note that this also means that a string may
    end with either 'CR LF' or 'CR NUL', but not with CR.)
          
Any object defined using this syntax may not exceed 255
characters in length.

Values & Constraints

Type Constraints

range: 0..255