fsMplsTunnelEndToEndProtection

This bitmask indicates the level of end to end protection required.  A
value of zero (no bits set) indicates that any protection may be
used.  The following describes these bitfields:
              
unprotected
  This flag is set to indicate that the LSP should not use any
   protection.
              
fullReroute
  This flag is set to indicate that the protecting LSP creation
  only when protected (primary) LSP fails.
              
rerouteWitoutExtraTraffic
  This flag is set to indicate that protecting LSP shall not
  carry traffic other than that of Primary LSP. In this case
  protecting LSP is usually not configured in the data plane
  before protected LSP failure.
              
dedicatedOneToOne
  This flag is set to indicate that a dedicated LSP
  protection scheme, i.e., 1:1 protection, should be used to
  support the LSP.
              
dedicatedUniOnePlusOne
  This flag is set to indicate that a dedicated LSP
  protection scheme, i.e., 1+1 protection, should be used to
  support the LSP. It is used for protecting uni-directional
  tunnel and No additional signalling is required for switching
  from one LSP to another in case of failure and recovery
              
dedicatedBiOnePlusOne
  This flag is set to indicate that a dedicated LSP
  protection scheme, i.e., 1+1 protection, should be used to
  support the LSP. It is used for protecting bi-directional
  tunnel and additional signalling is required for switching
  from one LSP to another in case of failure and recovery.

MIB

ARICENT-MPLS-TE-MIB

OID

.1.3.6.1.4.1.2076.13.12.1.2.1.8

Type

column

Access

readwrite

Status

current

Parent

fsMplsTunnelEntry