fsErpsRingConfigMultipleFailure

This object is configured in interconnection node of the sub-ring to
support the feature 'Minimizing segmentation in interconnected rings'
as per Appendix X of ITU-T G.8032/Y.1344 (03/2010) standard.
              
Configured value of the objects fsErpsRingConfigInterConnNode and
fsErpsRingConfigMultipleFailure is used in Block Indication Logic Procedure
as per Section X.3.2 in Appendix X of ITU-T G.8032/Y.1344 (03/2010) standard.
interconnected rings as described below :
    a) If Loss of connectivity between the interconnection nodes is detected
        and if the objects fsErpsRingConfigInterConnNode and
        fsErpsRingConfigMultipleFailure are configured to have identical
       values(i.e both are set to either primary or secondary) then Local MS
       command is applied on the subring port else loss of connectivity
       between the interconnection nodes is ignored.
    b) Similarly when loss of connectivity between the interconnection nodes
       is recovered and if the objects fsErpsRingConfigInterConnNode and
       fsErpsRingConfigMultipleFailure are configured to have identical values
       (i.e both are set to either primary or secondary) then Local MS command
       on the subring port is cleared else recovery of connectivity between the
       interconnection nodes is ignored.
              
This object is effective only when ring node is interconnection node.
              
The default value is disabled (0).
              
This object is applicable only when the compatible version is 2.

MIB

ARICENT-ERPS-MIB

OID

.1.3.6.1.4.1.29601.2.40.2.3.1.12

Type

column

Access

readwrite

Status

current

Parent

fsErpsRingConfigEntry