TPLINK-PIM-MIB Table View

The (conceptual) table listing the router's PIM interfaces.
IGMP and PIM are enabled on all interfaces listed in this
table.

tpPimInterfaceEntry row .1.3.6.1.4.1.11863.6.77.1.1.3.1

An entry (conceptual row) in the pimInterfaceTable.

Indexes

tpPimInterfaceIndex

Column	Syntax	OID
tpPimInterface Display the interface which you can configure.	OctetString Constraints: range: 0-25	.1.3.6.1.4.1.11863.6.77.1.1.3.1.1
tpPimInterfaceIndex The Index value of this PIM interface.	SNMPv2-SMIInteger32 Type Constraints: range: -2147483648..2147483647	.1.3.6.1.4.1.11863.6.77.1.1.3.1.2
tpPimInterfaceType The configured type of this interface.	Enumeration Enumerated Values: 0 vlan 1 loopback 2 routeport	.1.3.6.1.4.1.11863.6.77.1.1.3.1.3
tpPimInterfaceAddress The IP address of the PIM interface.	SNMPv2-SMIIpAddress Type Constraints: range: 4	.1.3.6.1.4.1.11863.6.77.1.1.3.1.4
tpPimInterfaceNetMask The network mask for the IP address of the PIM interface.	SNMPv2-SMIIpAddress Type Constraints: range: 4	.1.3.6.1.4.1.11863.6.77.1.1.3.1.5
tpPimInterfaceMode The configured mode of this PIM interface.	Enumerationr/w Enumerated Values: 0 disable 1 dense 2 sparse	.1.3.6.1.4.1.11863.6.77.1.1.3.1.6
tpPimInterfaceDRPriority The Designated Router Priority value inserted into the DR Priority option on this interface.Numerically higher values for this object indicate higher priorities.	SNMPv2-SMIInteger32r/w Type Constraints: range: -2147483648..2147483647	.1.3.6.1.4.1.11863.6.77.1.1.3.1.7
tpPimInterfaceDRAddress The Designated Router on this PIM interface. For point- to-point interfaces, this object has the value 0.0.0.0.	SNMPv2-SMIIpAddress Type Constraints: range: 4	.1.3.6.1.4.1.11863.6.77.1.1.3.1.8
tpPimInterfaceHelloInterval The frequency at which PIM Hello messages are transmitted on this interface.	secondsInteger32r/w Constraints: range: 1-18725	.1.3.6.1.4.1.11863.6.77.1.1.3.1.9
tpPimInterfaceBsrBorder The frequency at which PIM Hello messages are transmitted on this interface.	Enumerationr/w Enumerated Values: 0 disable 1 enable	.1.3.6.1.4.1.11863.6.77.1.1.3.1.10
tpPimInterfaceJoinPruneInterval The frequency at which PIM Join/Prune messages are transmitted on this PIM interface. This object corresponds to the 't_periodic' timer value defined in the PIM-SM specification [I-D.ietf-pim-sm-v2-new]. A value of …	secondsInteger32r/w Constraints: range: 1-18724	.1.3.6.1.4.1.11863.6.77.1.1.3.1.11

The (conceptual) table listing the router's PIM neighbors.

tpPimNeighborEntry row .1.3.6.1.4.1.11863.6.77.1.1.4.1

An entry (conceptual row) in the pimNeighborTable.

Indexes

tpPimNeighborAddress

Column	Syntax	OID
tpPimNeighborInterface The interface used to reach this PIM neighbor.	OctetString Constraints: range: 0-25	.1.3.6.1.4.1.11863.6.77.1.1.4.1.1
tpPimNeighborInterfaceIndex The value of ifIndex for the interface used to reach this PIM neighbor.	SNMPv2-SMIInteger32 Type Constraints: range: -2147483648..2147483647	.1.3.6.1.4.1.11863.6.77.1.1.4.1.2
tpPimNeighborAddress The IP address of the PIM neighbor for which this entry contains information.	SNMPv2-SMIIpAddress Type Constraints: range: 4	.1.3.6.1.4.1.11863.6.77.1.1.4.1.3
tpPimNeighborUpTime The time since this PIM neighbor (last) became a neighbor of the local router.	SNMPv2-SMITimeTicks Type Constraints: range: 0..4294967295	.1.3.6.1.4.1.11863.6.77.1.1.4.1.4
tpPimNeighborExpiryTime The minimum time remaining before this PIM neighbor will be aged out.	SNMPv2-SMITimeTicks Type Constraints: range: 0..4294967295	.1.3.6.1.4.1.11863.6.77.1.1.4.1.5
tpPimNeighborModedeprecated The active PIM mode of this neighbor. This object is deprecated for PIMv2 routers since all neighbors on the interface must be either dense or sparse as determined by the protocol running on the interface.	Enumeration Enumerated Values: 1 dense 2 sparse	.1.3.6.1.4.1.11863.6.77.1.1.4.1.6

The (conceptual) table listing PIM information for
candidate Rendezvous Points (RPs) for IP multicast groups.
When the local router is the BSR, this information is
obtained from received Candidate-RP-Advertisements.  When
the local router is not the BSR, this information is
obtained from received RP-Set messages.

tpPimCandidateRPSetEntry row .1.3.6.1.4.1.11863.6.77.1.1.7.1

An entry (conceptual row) in the pimRPSetTable.

Indexes

tpPimCRPSetInterfaceIndex

Column	Syntax	OID
tpPimCRPSetInterface The c rp interface.	OctetString Constraints: range: 0-25	.1.3.6.1.4.1.11863.6.77.1.1.7.1.1
tpPimCRPSetInterfaceIndex The ifIndex value of this c rp interface.	SNMPv2-SMIInteger32r/w Type Constraints: range: -2147483648..2147483647	.1.3.6.1.4.1.11863.6.77.1.1.7.1.2
tpPimCRPSetInterfaceTypedeprecated The interface type.	Enumeration Enumerated Values: 0 vlan 1 loopback 2 routeport	.1.3.6.1.4.1.11863.6.77.1.1.7.1.3
tpPimCRPSetPriority Specify the priority of the candidate RP. The default value is 192.	Integer32r/w Constraints: range: 0-255	.1.3.6.1.4.1.11863.6.77.1.1.7.1.4
tpPimCRPSetInterVal Specify the interval of advertisement message of the candidate RP in seconds. The default value is 60.	Integer32r/w Constraints: range: 1-255	.1.3.6.1.4.1.11863.6.77.1.1.7.1.5
tpPimCRPSetNextAdvertisementTime Show the remain time of next RP advertisement packet send.	SNMPv2-SMITimeTicks Type Constraints: range: 0..4294967295	.1.3.6.1.4.1.11863.6.77.1.1.7.1.6
tpPimCRPSetInterfaceStatusdeprecated The interface type.	Enumerationr/w Enumerated Values: 0 disable 1 enable	.1.3.6.1.4.1.11863.6.77.1.1.7.1.7