DOCS-LOADBAL3-MIB Table View

This object reports the status of cable modems instructed
to move to a new downstream and/or upstream channel
or channel sets when commanded either by an operation
in the ChgOver object. An instance in this object
is created for each change-over operation committed
successfully. If the instance value attribute
is not final (the change-over operation is still pending
completion), this instance is expected to be updated
at some point later to reflect the final state
of the change-over operation.

This object represents the autonomous load balancing
parameters provisioned for cable modem. The CMTS
selects the cable modem Load Balancing Group (GrpId
attribute of this object) from multiple sources by
following the rules and sequence described below:
          
The CMTS selects the assignment of the CM to a Load Balancing
Group by determining first if the CM is in a Restricted
Load Balancing Group or in its absence to the General
Load Balancing group that corresponds to the
MD-CM-SG of the CM. The selection of the Restricted Load
Balancing group is achieved by first matching the
CM in the RestrictCmCfg Object and if no match is found,
by selecting the best match within the ResGrpCfg
object. 
The best match within the ResGrpCfg follows the MULPI
requirements on precedences of the CM signaled TLVs:
ServiceType ID and Load Balancing Group ID (for backward
compatibility of provisioned Group IDs).

This object provides the parameters for the General
Load Balancing Groups of MD-CM-SGs associated with
MAC Domain-Fiber Node pairs. This object allows configuration
of load balancing parameters for General
Load Balancing Groups by way of MAC Domain-Fiber
Node pairs.  In many deployments, a MAC Domain-Fiber
Node pair will equate to an MD-CM-SG (which always equates
to a GLBG).  In the case where an MD-CM-SG spans multiple
Fiber Nodes, there will be multiple instances
of this object that represent the General Load Balancing
Group (MD-CM-SG).  The CMTS MUST enforce that
such instances all have the same attribute values.  Any
time a fiber node is associated to a MAC Domain an instance
of this object is defined by the CMTS and populated
with default values from the GeneralGrpDefaults
object. Similarly when a fiber node is no longer paired
with a MAC Domain the corresponding instance is
deleted from the object.

This object represents the configuration of Restricted
Load Balancing Groups.

This object represents the status of all General
and Restricted Load Balancing Groups in this CMTS.
This object summarizes the load balancing parameters
that applies to CMTS system wide Load Balancing Groups.
The Load Balancing Groups defined in this object
include the configured Restricted Load Balancing
Groups and the General Load Balancing Groups derived
from the GeneralGrpCfg object.

This object describes the list of cable modems being
statically provisioned at the CMTS to a Restricted
Load Balancing Group.
When a CM registers it is either assigned to

This object describes the set of load balancing policies.
Instances from this object might be referenced
by GrpStatus object . All the rules contained in a
load balancing policy apply to an Autonomous Load Balancing
operations. Load balancing rules are defined
within this specification or can be vendor-defined
as well.

This object represents a basic ruleset applicable
to a load balancing policy that references it.