DLINKPRIME-CABLE-DIAG-MIB Table View

A table contains a list of information about test on the device's 	
interfaces. Note that entries will exist in this table when the 
corresponding interface is capable to run test.

dpCableDiagIfEntry row .1.3.6.1.4.1.171.15.1.1.1.1

An entry in the dpCableDiagIfTable, contains the
testing controls on an interface.

Indexes

IF-MIBifIndex

Column	Syntax	OID
dpCableDiagIfAction This object control the action to be executed on the interface. noOp(1) - No action is taken if this object is set to 'noOp'. When read, the value 'noOp' is returned. …	Enumerationr/w Enumerated Values: 1 noOp 2 test 3 clear	.1.3.6.1.4.1.171.15.1.1.1.1.1

A table contains a list of interface's cable situation.
Note that entries will exist in this table when the 
corresponding interface is a copper Ethernet port.

dpCableDiagResultEntry row .1.3.6.1.4.1.171.15.1.1.2.1

An entry in dpCableDiagResultTable contains cable situation
of an interface.

Indexes

IF-MIBifIndex

Column	Syntax	OID
dpCableDiagResultCableStatus The status of a pair of the cable. no_result(0) - The cable have not do cable daig or result have been clear. ok(1) - The pair or cable has no error. noCable(2) - The port does not have any…	Enumeration Enumerated Values: 0 no_result 1 ok 2 no_cable 3 open 4 short 5 openshort 6 crosstalk	.1.3.6.1.4.1.171.15.1.1.2.1.1
dpCableDiagResultCableLength This object indicates the approximate length or length to the failure of the cable. This value is in meter units. The special value of -1 indicates the length is unavailable.	metersSNMPv2-SMIInteger32 Type Constraints: range: -2147483648..2147483647	.1.3.6.1.4.1.171.15.1.1.2.1.2
dpCableDiagLinkStatus The current link operational state of the interface.	Enumeration Enumerated Values: 0 no_result 1 up 2 down	.1.3.6.1.4.1.171.15.1.1.2.1.3
dpCableDiagInterfaceType The current port type of the interface.	Enumeration Enumerated Values: 0 no_result 1 type_1000BASET 2 type_1000BASEX	.1.3.6.1.4.1.171.15.1.1.2.1.4