CISCO-ADSL-CAP-LINE-MIB Table View

This table extends the adslAtucPhysTable and contains
enterprise-specific physical layer parameters for the ATU-C
class devices supported by the system.

cAdslAtucCapPhysEntry row .1.3.6.1.4.1.9.9.149.1.2.1

A set of enterprise-specific physical-layer parameters for an
ATU-C class device supported by the system. There exists an
entry for each ifEntry with an ifType of adsl(94) and an
adslLineCoding of cap(3).

Indexes

IF-MIBifIndex

Column	Syntax	OID
cAdslAtucCapCurrState This object specifies the state of the ATU-C transceiver. The value of this managed is 'idle' for an ATU-C that has been provisioned, but is not physically present in the system.	Enumeration Enumerated Values: 1 other 2 idle 3 training 4 steadyState 5 downloading 6 downloadFailed 7 testing	.1.3.6.1.4.1.9.9.149.1.2.1.1
cAdslAtucCapCurrRxGain This managed object represents the gain applied to the ATU-C receiver. The value of this managed object is '0' for an ATU-C that has been provisioned, but is not physically present in the system.	tenth dBSNMPv2-SMIGauge32 Type Constraints: range: 0..4294967295	.1.3.6.1.4.1.9.9.149.1.2.1.2
cAdslAtucCapCurrRxSnr This managed object represents the signal-to-noise ratio measured across the the ATU-C receive pair. The value of this managed object is '0' for an ATU-C that has been provisioned, but is not physically p…	tenth dBSNMPv2-SMIGauge32 Type Constraints: range: 0..4294967295	.1.3.6.1.4.1.9.9.149.1.2.1.3

This table extends the adslAturPhysTable and contains
enterprise-specific physical layer parameters for the ATU-R
class devices supported by the system.

cAdslAturCapPhysEntry row .1.3.6.1.4.1.9.9.149.1.3.1

A set of enterprise-specific physical-layer parameters for an
ATU-R class device supported by the system. There exists an
entry for each ifEntry with an ifType of adsl(94) and an
adslLineCoding of cap(3).

Indexes

IF-MIBifIndex

Column	Syntax	OID
cAdslAturCapCurrRxGain This managed object represents the gain applied to the ATU-R receiver. The value of this managed object is '0' if the corresponding ATU-C has been provisioned, but is not physically present in the system.	tenth dBSNMPv2-SMIGauge32 Type Constraints: range: 0..4294967295	.1.3.6.1.4.1.9.9.149.1.3.1.1

This table extends the adslAtucPerfDataTable and contains
enterprise-specific physical layer statistics for the ATU-C
class devices supported by the system.

cAdslAtucCapPerfDataEntry row .1.3.6.1.4.1.9.9.149.1.6.1

A set of enterprise-specific physical-layer statistics for an
ATU-C class device supported by the system. There exists an
entry for each ifEntry with an ifType of adsl(94) and an
adslLineCoding of cap(3).

Indexes

IF-MIBifIndex

Column	Syntax	OID
cAdslAtucCapPerfInitFailures This object specifies the number of line initialization failures relative to sysUpTime.	SNMPv2-SMICounter32 Type Constraints: range: 0..4294967295	.1.3.6.1.4.1.9.9.149.1.6.1.1
cAdslAtucCapPerfCurr15MinInitFailures This object specifies the number of line initialization failures in the current 15-minute interval.	PerfHist-TC-MIBPerfCurrentCount	.1.3.6.1.4.1.9.9.149.1.6.1.2
cAdslAtucCapPerfCurr1DayInitFailures This object specifies the number of line initialization failures in the current 1-day interval.	ADSL-TC-MIBAdslPerfCurrDayCount	.1.3.6.1.4.1.9.9.149.1.6.1.3
cAdslAtucCapPerfPrev1DayInitFailures This object specifies the number of line initialization failures in the previous 1-day interval.	ADSL-TC-MIBAdslPerfPrevDayCount	.1.3.6.1.4.1.9.9.149.1.6.1.4

This table extends the adslAtucIntervalTable and contains
enterprise-specific physical layer statistics intervals for
the ATU-C class devices supported by the system.

cAdslAtucCapIntervalEntry row .1.3.6.1.4.1.9.9.149.1.8.1

A 15-minute interval of enterprise-specific physical-layer
statistics for an ATU-C class device supported by the system.
There exists up to 96 entries for each ifEntry with an ifType
of adsl(94) and an adslLineCoding of…

Indexes

IF-MIBifIndex ADSL-LINE-MIBadslAtucIntervalNumber

Column	Syntax	OID
cAdslAtucCapIntervalInitFailures This object specifies the number of line initialization failures in the interval.	PerfHist-TC-MIBPerfIntervalCount	.1.3.6.1.4.1.9.9.149.1.8.1.1

This table extends the adslLineConfProfileTable and contains
enterprise-specific ADSL line configuration information.

cAdslLineCapConfProfileEntry row .1.3.6.1.4.1.9.9.149.1.14.1

A configuration profile containing enterprise-specific ADSL
line configuration information.

Indexes

ADSL-LINE-MIBadslLineConfProfileName

Column	Syntax	OID
cAdslLineCapConfTrainingMode This object specifies the mode employed by the ATU-C and ATU-R when training against each other. One of two training modes can be employed: - Standard An ATU-C initiates a training sequence using the…	Enumerationr/w Enumerated Values: 1 standard 2 fast	.1.3.6.1.4.1.9.9.149.1.14.1.1
cAdslLineCapConfInterleaveDelay This object specifies the interleave delay for the downstream channel. The value of this object specifies the mapping (relative spacing) between subsequent input bytes at the interleaver input and their placement in th…	Enumerationr/w Enumerated Values: 1 none 2 short 3 long	.1.3.6.1.4.1.9.9.149.1.14.1.2
cAdslLineCapConfCpeSignature This object specifies the value of the minimum CPE signature expected from ATU-R during training. The value of the CPE signature corresponds to the software version of the ATU-R. If the CPE signature adv…	Integer32r/w Constraints: range: 0-127	.1.3.6.1.4.1.9.9.149.1.14.1.3
cAdslAtucCapConfTargetSnrMgn This object specifies the target SNR margin. This is the desired noise margin the ATU-C must achieve with a BER of 10-7 or better to successfully complete training.	tenth dBInteger32r/w Constraints: range: 0-310	.1.3.6.1.4.1.9.9.149.1.14.1.4
cAdslAtucCapConfMinTxRate This object specifies the minimum acceptable downstream line rate.	bpsAdslLineCapDownstreamRater/w Type Constraints: range: 0 range: 256000 range: 384000 range: 512000 range: 640000 range: 768000 range: 896000 range: 960000 range: 1024000 range: 1280000 range: 1600000 range: 1920000 range: 2240000 range: 2560000 range: 2688000 range: 3200000 range: 4480000 range: 5120000 range: 6272000 range: 7168000	.1.3.6.1.4.1.9.9.149.1.14.1.5
cAdslAtucCapConfMaxTxRate This object specifies the desired line rate which the ATU-C will attempt to train at.	bpsAdslLineCapDownstreamRater/w Type Constraints: range: 0 range: 256000 range: 384000 range: 512000 range: 640000 range: 768000 range: 896000 range: 960000 range: 1024000 range: 1280000 range: 1600000 range: 1920000 range: 2240000 range: 2560000 range: 2688000 range: 3200000 range: 4480000 range: 5120000 range: 6272000 range: 7168000	.1.3.6.1.4.1.9.9.149.1.14.1.6
cAdslAtucCapConfDown136KBaudEnable This object specifies whether the modem can train the downstream channel using a symbol rate of 136K symbols per second.	SNMPv2-TCTruthValuer/w Type Values: 1 true 2 false Description: Represents a boolean value.	.1.3.6.1.4.1.9.9.149.1.14.1.7
cAdslAtucCapConfUp68KBaudEnable This object specifies whether the modem can train the upstream channel using a symbol rate of 68K symbols per second. The value of this object does not effect whether the modem can train at any other symb…	SNMPv2-TCTruthValuer/w Type Values: 1 true 2 false Description: Represents a boolean value.	.1.3.6.1.4.1.9.9.149.1.14.1.8
cAdslAtucCapConfUp17KBaudEnable This object specifies whether the modem can train the upstream channel using a symbol rate of 17K symbols per second. The value of this object does not effect whether the modem can train at any other symb…	SNMPv2-TCTruthValuer/w Type Values: 1 true 2 false Description: Represents a boolean value.	.1.3.6.1.4.1.9.9.149.1.14.1.9
cAdslAtucCapConfPsdmLevel This managed object specifies the nominal power output of the ATU-C across the entire transmit spectrum. Observe that this implies the attenuation of the signal for some data rates. This value does not t…	dBm/HzInteger32r/w Constraints: range: -52--52 range: -49--49 range: -46--46 range: -43--43 range: -40--40 range: -37--37	.1.3.6.1.4.1.9.9.149.1.14.1.10
cAdslAturCapConfTargetSnrMgn This object specifies the target SNR margin. This is the desired noise margin the ATU-R must achieve with a BER of 10-7 or better to successfully complete training.	tenth dBInteger32r/w Constraints: range: 0-310	.1.3.6.1.4.1.9.9.149.1.14.1.11
cAdslAturCapConfMinTxRate This object specifies the minimum acceptable upstream line rate.	bpsAdslLineCapUpstreamRater/w Type Constraints: range: 0 range: 91000 range: 272000 range: 408000 range: 544000 range: 680000 range: 816000 range: 952000 range: 1088000	.1.3.6.1.4.1.9.9.149.1.14.1.12
cAdslAturCapConfMaxTxRate This object specifies the desired line rate which the ATU-R will attempt to train at.	bpsAdslLineCapUpstreamRater/w Type Constraints: range: 0 range: 91000 range: 272000 range: 408000 range: 544000 range: 680000 range: 816000 range: 952000 range: 1088000	.1.3.6.1.4.1.9.9.149.1.14.1.13
cAdslAturCapConfPsdmLevel This managed object specifies the nominal power output of the ATU-R across the entire transmit spectrum. Observe that this implies the attenuation of the signal for some data rates. This value does not t…	dBm/HzInteger32r/w Constraints: range: -53--53 range: -50--50 range: -47--47 range: -44--44 range: -41--41 range: -38--38	.1.3.6.1.4.1.9.9.149.1.14.1.14