BEGEMOT-ATM-MIB Table View

This table contains an entry for each hardware ATM
interface. The table is indexed by the interface index.

begemotAtmIfEntry row .1.3.6.1.4.1.12325.1.101.1.1.1

This is a table entry describing one ATM hardware interface.

Indexes

IF-MIBifIndex

Column	Syntax	OID
begemotAtmIfName Name of the ATM interface.	OctetString Constraints: range: 1-15	.1.3.6.1.4.1.12325.1.101.1.1.1.1
begemotAtmIfPcr The line cell rate of the interface.	SNMPv2-SMIUnsigned32 Type Constraints: range: 0..4294967295	.1.3.6.1.4.1.12325.1.101.1.1.1.2
begemotAtmIfMedia The physical medium.	Enumeration Enumerated Values: 1 other 3 unknown 4 utp25 5 taxi100 6 taxi140 7 mm155 8 sm155 9 utp155 10 mm622 11 sm622 12 virtual	.1.3.6.1.4.1.12325.1.101.1.1.1.3
begemotAtmIfVpiBits Number of VPI bits that are used by the device.	Unsigned32 Constraints: range: 0-12	.1.3.6.1.4.1.12325.1.101.1.1.1.4
begemotAtmIfVciBits Number of VCI bits that are used by the device.	Unsigned32 Constraints: range: 0-16	.1.3.6.1.4.1.12325.1.101.1.1.1.5
begemotAtmIfMaxVpcs The maximum number of VPC supported on this device. This may not be larger than 2^begemotAtmIfVpiBits.	Unsigned32 Constraints: range: 0-256	.1.3.6.1.4.1.12325.1.101.1.1.1.6
begemotAtmIfMaxVccs The maximum number of VCC supported on this device. This may not be larger than 2^(begemotAtmIfVpiBits + begemotAtmVciBits).	Unsigned32 Constraints: range: 0-16777216	.1.3.6.1.4.1.12325.1.101.1.1.1.7
begemotAtmIfEsi The default End System Identifier as reported by the hardware. If the hardware has no ESI all six bytes are reported as 0.	AtmESI Type Constraints: range: 6	.1.3.6.1.4.1.12325.1.101.1.1.1.8
begemotAtmIfCarrierStatus The state of the carrier. For interfaces which don't have the notion of a carriere none is reported.	Enumeration Enumerated Values: 1 carrierOn 2 carrierOff 3 unknown 4 none	.1.3.6.1.4.1.12325.1.101.1.1.1.9
begemotAtmIfMode The mode of the SUNI interface. For interfaces without SUNI unknown is reported in which case the variable is read-only. Some types of interfaces may not be able to change this value.	Enumerationr/w Enumerated Values: 1 sonet 2 sdh 3 unknown	.1.3.6.1.4.1.12325.1.101.1.1.1.10

This table augments the begemotAtmIfTable and contains an entry
for each hardware ATM interface. The entries describe the
ATM hardware interface.

begemotAtmHWEntry row .1.3.6.1.4.1.12325.1.101.1.3.1

This is a table entry describing one ATM hardware interface.

Indexes

No indexes recorded

Column	Syntax	OID
begemotAtmHWVendor A short string naming the vendor of the interface card.	SNMPv2-TCDisplayString Type Constraints: range: 0..255 Description: Represents textual information taken from the NVT ASCII character set, as defined in pages 4, 10-11 of RFC 854. To summarize RFC 854, the NVT ASCII repertoire specifies: - the use of c…	.1.3.6.1.4.1.12325.1.101.1.3.1.1
begemotAtmHWDevice A short string naming the brand of the interface card.	SNMPv2-TCDisplayString Type Constraints: range: 0..255 Description: Represents textual information taken from the NVT ASCII character set, as defined in pages 4, 10-11 of RFC 854. To summarize RFC 854, the NVT ASCII repertoire specifies: - the use of c…	.1.3.6.1.4.1.12325.1.101.1.3.1.2
begemotAtmHWSerial The serial number of the interface card or 0 if it doesn't report a serial number.	SNMPv2-SMIUnsigned32 Type Constraints: range: 0..4294967295	.1.3.6.1.4.1.12325.1.101.1.3.1.3
begemotAtmHWVersion The hardware version of the interface card or 0 if it doesn't report a hardware version number.	SNMPv2-SMIUnsigned32 Type Constraints: range: 0..4294967295	.1.3.6.1.4.1.12325.1.101.1.3.1.4
begemotAtmHWSoftVersion The firmware version of the interface card or 0 if it doesn't report a firmware version number.	SNMPv2-SMIUnsigned32 Type Constraints: range: 0..4294967295	.1.3.6.1.4.1.12325.1.101.1.3.1.5