A3COM0420-SWITCH-EXTENSIONS Table View

Table providing configuration information about a port on a
          
Switch unit.

prConfigPortEntry row .1.3.6.1.4.1.43.10.34.2.1.1

Configuration options for a single port.

Indexes

RFC1213-MIBifIndex

Column	Syntax	OID
prConPortVLANConfigModemandatory This object specifies the VLAN mode to be used. Setting it to portMode(3) requires the user to configure the port's VLAN membership explicitly, whereas autoSelect(4) causes it to …	Enumerationr/w Enumerated Values: 1 notApplicable 2 useDefault 3 portMode 4 autoSelect	.1.3.6.1.4.1.43.10.34.2.1.1.1
prConPortIFMmandatory This object controls Intelligent Flow Management for the port, which specifies what action the port takes whenever it is unable to receive a packet because its buffers are full. When set to…	Enumerationr/w Enumerated Values: 1 notApplicable 2 off 3 maxJams6 4 maxJams7 5 maxJams8 6 maxJams9 7 maxJams10 8 maxJams11 9 maxJams12 10 maxJams13	.1.3.6.1.4.1.43.10.34.2.1.1.13
prConPortLacpmandatory This object specifies whether a port will use LACP. When enabled LACP will be active on the port. When disabled LACP will cease this may cause a port to be taken out of an …	Enumerationr/w Enumerated Values: 1 enable 2 disable	.1.3.6.1.4.1.43.10.34.2.1.1.14
prConPortStpAdminPathCostmandatory The administratively assigned value of the path cost for this port. The contribution of this port to the path cost of paths towards the spanning tree root which include this port. 802.1D-1990 recommends that the default…	Integer32r/w Constraints: range: 0-200000000	.1.3.6.1.4.1.43.10.34.2.1.1.15
prConPortCascadeModemandatory This object specifies whether the port is a cascade port or not. If enabled, the port is operating as a cascade port. If disabled, the port is not operating as a cascade port.	Enumeration Enumerated Values: 1 enabled 2 disabled	.1.3.6.1.4.1.43.10.34.2.1.1.16

This table provides the same information as that held in the
          
dot1qTpFdbTable in the Bridge Extension MIB.

prConPortFdbEntry row .1.3.6.1.4.1.43.10.34.2.2.1

Information about a specific unicast MAC address.

Indexes

prConPortFdbPort prConPortFdbId prConPortFdbAddress

Column	Syntax	OID
prConPortFdbPortmandatory This contains the port number that this address has been seen on. It is similar to dot1qTpFdbPort in the Bridge Extensions MIB but may not be the value zero.	Integer32 Constraints: range: 0-65535	.1.3.6.1.4.1.43.10.34.2.2.1.1
prConPortFdbIdmandatory The identity of this filtering database. This shall have the same value as is defined for dot1qFdbId in the bridge MIB extensions MIB.	Integer32 Type Constraints: range: -2147483648..2147483647	.1.3.6.1.4.1.43.10.34.2.2.1.2
prConPortFdbAddressmandatory This object contains the unicast MAC address of the entry. This contains the same value as dot1qTpFdbAddress in the Bridge Extensions MIB.	SNMPv2-TCMacAddress Type Constraints: range: 6 Description: Represents an 802 MAC address represented in the `canonical' order defined by IEEE 802.1a, i.e., as if it were transmitted least significant bit first, even though 802.5 (in contrast to other 802.x protocols) requires M…	.1.3.6.1.4.1.43.10.34.2.2.1.3
prConPortFdbStatusmandatory This contains the same information as dot1qTpFdbStatus in the Bridge Extensions MIB.	Enumeration Enumerated Values: 1 other 2 invalid 3 learned 4 self 5 mgmt	.1.3.6.1.4.1.43.10.34.2.2.1.4

Table for distributing multicast addresses on trunks across a
          
stack.

prConTrunkMulticastEntry row .1.3.6.1.4.1.43.10.34.2.3.1

Information associated with a single multicast entry.

Indexes

prConTrunkMulticastFdbId prConTrunkMulticastAddress

Column	Syntax	OID
prConTrunkMulticastFdbIdmandatory The identity of the filtering database. This contains the same value as dot1qFdbId in the Bridge Extensions MIB.	Integer32 Type Constraints: range: -2147483648..2147483647	.1.3.6.1.4.1.43.10.34.2.3.1.1
prConTrunkMulticastAddressmandatory This object contains the multicast MAC address of the entry. This contains the same value as the dot1qTpGroupAddress in the Bridge Extensions MIB	SNMPv2-TCMacAddress Type Constraints: range: 6 Description: Represents an 802 MAC address represented in the `canonical' order defined by IEEE 802.1a, i.e., as if it were transmitted least significant bit first, even though 802.5 (in contrast to other 802.x protocols) requires M…	.1.3.6.1.4.1.43.10.34.2.3.1.2
prConTrunkMulticastPortlistmandatory The set of trunk ports to which frames destined for this multicast address should be forwarded. Each octet within the value of this object specifies a set or eight trunk ports, with …	OctetStringr/w	.1.3.6.1.4.1.43.10.34.2.3.1.3
prConTrunkMulticastStatusmandatory This object specifies the status of the entry. The default value is other(1). This object contains the same information as dot1dStaticStatus in RFC1493.	Enumerationr/w Enumerated Values: 1 other 2 invalid 3 permanent 4 deleteOnReset 5 deleteOnTimeout	.1.3.6.1.4.1.43.10.34.2.3.1.4
prConTrunkMulticastTypemandatory This object contains the same information as dot1qTpFdbStatus in the Bridge Extensions MIB.	Enumerationr/w Enumerated Values: 1 other 2 invalid 3 learned 4 self 5 mgmt	.1.3.6.1.4.1.43.10.34.2.3.1.5
prConTrunkMulticastRobpmandatory This object contains the Receive on Blocked port setting.	Enumeration Enumerated Values: 1 true 2 false	.1.3.6.1.4.1.43.10.34.2.3.1.6

Table for translating between unit.port and ifIndex or bridge
          
port number.

prConIfIndexEntry row .1.3.6.1.4.1.43.10.34.2.4.1

The IfIndex and bridge port number associated with a port

entry.

Indexes

prConIfIndexGroupIndex prConIfIndexPortIndex

Column	Syntax	OID
prConIfIndexGroupIndexmandatory This object identifies the group, unit or blade containing the port for which this entry contains information.	Integer32 Constraints: range: 1-1024	.1.3.6.1.4.1.43.10.34.2.4.1.1
prConIfIndexPortIndexmandatory This object identifies the port within the group for which this entry contains information.	Integer32 Constraints: range: 1-1024	.1.3.6.1.4.1.43.10.34.2.4.1.2
prConIfIndexmandatory This object contains the corresponding ifIndex value.	Integer32 Type Constraints: range: -2147483648..2147483647	.1.3.6.1.4.1.43.10.34.2.4.1.3
prConIfIndexBridgePortmandatory The corresponding bridge port number, which is the number of the port as defined by RFC1493. If a port is a member of an aggregation, the value will be that of the aggregation rather …	Integer32 Constraints: range: 1-65535	.1.3.6.1.4.1.43.10.34.2.4.1.4

Table providing configuration information about an aggregation
on a Switch unit.

prConfigAggEntry row .1.3.6.1.4.1.43.10.34.2.5.1

Configuration information for a single aggregation.

Indexes

RFC1213-MIBifIndex

Column	Syntax	OID
prConfigAggStatusmandatory This object specifies the aggregation status. The status is indicated as follows: unused(1) the aggregation is not presently in use. autoInUse(2) the aggregation was selected as a result of …	Enumeration Enumerated Values: 1 unused 2 autoInUse 3 autoAgeing 4 autoReusable 5 manual	.1.3.6.1.4.1.43.10.34.2.5.1.1