zyLoopGuardState

ZYXEL-LOOPGUARD-MIB · .1.3.6.1.4.1.890.1.15.3.45.1.1
MIB view Table view

Object

scalar r/w P-BRIDGE-MIBEnabledStatus 
Enable/Disable loop guard on the switch. 
Loop guard allows you to configure the switch to shut down a port if it detects that packets 
sent out on that port loop back to the switch. Loop guard is designed to handle loop problems 
on the edge of your network. This can occur when a port is connected to a switch that is in a 
loop state. Loop state occurs as a result of human error. For example, it happens when two ports 
on a switch are connected with the same cable. When a switch in loop state sends out broadcast 
messages the messages loop back to the switch and are re-broadcast again and again causing a 
broadcast storm.

Context

MIB
ZYXEL-LOOPGUARD-MIB
OID
.1.3.6.1.4.1.890.1.15.3.45.1.1
Type
scalar
Access
readwrite
Status
current
Parent
zyxelLoopGuardSetup
Siblings
1

Syntax

P-BRIDGE-MIBEnabledStatus
Source
P-BRIDGE-MIBEnabledStatus
Base type
Enumeration

Values & Constraints

Type Values
1enabled
2disabled

Related Objects

Sibling Objects
ObjectTypeSyntaxOID
zyxelLoopGuardPortTable
The table contains loop guard port configuration.
table-.1.3.6.1.4.1.890.1.15.3.45.1.2