zxPwCTDMCurrentIndications

The following defects should be detected and reported
upon request:
              
-Stray packets MAY be detected by the PSN and multiplexing
layers. Stray packets MUST be discarded by the CE-bound IWF
and their detection MUST NOT affect mechanisms for detection
of packet loss.
              
-Malformed packets are detected by mismatch between the
expected packet size (taking the value of the L bit into
account) and the actual packet size inferred from the PSN and
multiplexing layers. Malformed in-order packets MUST be
discarded by the CE-bound IWF and replacement data generated
as for lost packets.
              
-Excessive packet loss rate is detected by computing the
average packet loss rate over the value of
zxPwCTDMAvePktLossTimeWindow and comparing it with a
preconfigured threshold [SATOP].
              
-Buffer overrun is detected in the normal operation state
when the CE bound IWF's jitter buffer cannot accommodate
newly arrived packets.
              
-Remote packet loss is indicated by reception of packets with
their R bit set.
              
-Packet misorder is detected by looking at the Sequence
number provided by the control word.
              
-TDM Fault, if L bit in the control word is set, it indicates
that TDM data carried in the payload is invalid due an
attachment circuit fault.  When the L bit is set the payload
MAY be omitted in order to conserve bandwidth.
              
Note: the algorithm used to capture these indications
is implementation specific.

MIB

ZXPW-TDM-MIB

OID

.1.3.6.1.4.1.3902.1015.1013.2.1.2.1.1.1.9

Type

column

Access

readonly

Status

current

Parent

zxPwCTDMEntry

Table

zxPwCTDMTable

Siblings

10