upsConfigHighVoltageTransferPoint
UPS-MIB ·
.1.3.6.1.2.1.33.1.9.10
Object
scalar
r/w
RMS Volts NonNegativeInteger
The maximum line voltage allowed before the UPS system transfers to battery backup.
Syntax
RMS Volts NonNegativeInteger
- Source
- NonNegativeInteger
- Base type
Integer32
Values & Constraints
Type Constraints
range: 0..2147483647
Related Objects
Sibling Objects
| Object | Type | Syntax | OID |
|---|---|---|---|
| upsConfigInputVoltage The magnitude of the nominal input voltage. On those
systems which support read-write access to this
object, if there is an attempt to set this variable to
a value that is not su… | scalar | RMS Volts NonNegativeInteger | .1.3.6.1.2.1.33.1.9.1 |
| upsConfigInputFreq The nominal input frequency. On those systems which
support read-write access to this object, if there is
an attempt to set this variable to a value that is not
supported, the re… | scalar | 0.1 Hertz NonNegativeInteger | .1.3.6.1.2.1.33.1.9.2 |
| upsConfigOutputVoltage The magnitude of the nominal output voltage. On
those systems which support read-write access to this
object, if there is an attempt to set this variable to
a value that is not s… | scalar | RMS Volts NonNegativeInteger | .1.3.6.1.2.1.33.1.9.3 |
| upsConfigOutputFreq The nominal output frequency. On those systems which
support read-write access to this object, if there is
an attempt to set this variable to a value that is not
supported, the r… | scalar | 0.1 Hertz NonNegativeInteger | .1.3.6.1.2.1.33.1.9.4 |
| upsConfigOutputVA The magnitude of the nominal Volt-Amp rating. | scalar | Volt-Amps NonNegativeInteger | .1.3.6.1.2.1.33.1.9.5 |
| upsConfigOutputPower The magnitude of the nominal true power rating. | scalar | Watts NonNegativeInteger | .1.3.6.1.2.1.33.1.9.6 |
| upsConfigLowBattTime The value of upsEstimatedMinutesRemaining at which a
lowBattery condition is declared. For agents which
support only discrete (discontinuous) values, then the
agent shall round u… | scalar | minutes NonNegativeInteger | .1.3.6.1.2.1.33.1.9.7 |
| upsConfigAudibleStatus The requested state of the audible alarm. When in
the disabled state, the audible alarm should never
sound. The enabled state is self-describing. Setting
this object to muted(3… | scalar | Enumeration | .1.3.6.1.2.1.33.1.9.8 |
| upsConfigLowVoltageTransferPoint The minimum input line voltage allowed before the UPS
system transfers to battery backup. | scalar | RMS Volts NonNegativeInteger | .1.3.6.1.2.1.33.1.9.9 |